Need to know how to clean the taylor soft serve machine and start it as well. Bought a taylor soft serve machine but do not know how to operate. Soft server machine made by Taylor.

Question edited for clarity.
Question moved from Heating and Cooling to Taylor Ice Cream.

Manual

OPERATOR'S MANUAL Model 8752, 8756 and 8757 Soft ...

https://www.taylor-company.com > downloadables
PDF
Soft-Serve Freezers ... Complete this page for quick reference when service is required: ... When the machine cycles off, product in the freezing.
Viscosity adjustment screw.

Taylor Softech Ice Cream Machine Settings & Adjustments

https://softserveparts.com > p-37224-taylor-softech-con...
Learn how to adjust your Taylor Softech ice cream machine using the control board. ... turn the viscosity adjustment screw SLOWLY until the unit cycles off.


..

have them back you paid to have it fixed and they havent

It's either:

A. The drive shaft boot seal - 032560 Boot Seal - You can buy them individually or as part of the tune up kit. They are normally replaced quarterly. Inspect this part when you take the drive shaft out for cleaning. It's very important that the drive shaft comes out every time you clean the machine and that you pack lubricant between the seal and the shaft.

B. The Shell Bearing - Taylor 031324 Replacement Rear Shell Bearing This is the metal sleeve that the drive shaft goes through in the back of the freezing cylinder. They wear out over time, they usually start to "mushroom" out grind down the boot seal.






Email me if you need a part or more help.
[email protected]

The Taylor C709 is a Heat Treat machine. Most soft serve machines have to be cleaned out every 3rd night and sanitized. Heat Treatment machines heat the mix up to a high temperature that kills bacteria and allows you to disassemble and sanitize the machine much less often. I can't tell you why, but the machine you are dealing with isn't running that heat cycle.

The Taylor 152 is at the low end of output when it comes to commercial soft serve equipment. It is rated for 102 3.5oz. servings per hour, but only 4 3.5oz rapid servings before it needs time to recover.
Possible remedies:
When you need to serve several cones in a row, you can pull the feed tube in the top. That will help the product fill the cylinder a little faster.
You could always consider a used Taylor machine that has the ability to keep up with your demand. Soft Serve Parts Taylor Machines

Soft Serve Parts Supplies


Parts here
Soft Serve Parts Supplies

check start and run components if the unit is single phase.

Don't know if this helps:
http://www.taylor-company.com/sites/files/taylor/0750,751,754,774,791,794op0.pdf
on page 24

Dear friend, Well if you are planning to buy an ice-cream machine.i can provide you a few links.
for 339-27 ice cream mashin 1)http://shop.ebay.com/sis.html?_nkw=TAYLOR+339+27+SOFT+SERVE+ICE+CREAM+MACHINE+AIR+COOLED
2)wvw.lucantoniblanz.tk/taylor-339-27-ice-cream-machine
3)http://www.fashioninpassion.com/index.php?jeans=simac+il+gelataio&pj=67167


Price:$2392.0 - Taylor Soft Serve Ice Cream Machine Model 339-27 for the 3rd website
the cost is ranging from $1,995.00 to $7,500.00 (cost on ebay.com)

the below link will guide you in a more better way.

http://shop.ebay.com/sis.html?_nkw=Taylor+754+33+Soft+Serve+Ice+Cream+Machine+Air+Cooled
Buy It Nowor Best Offer $7,500.00

754-27 Taylor soft serve machine Beater motor not running - compressor not engaging - Power to beater relay but not out of relay.