No power my monitor will not turn on at all, the blue light on the front will turn ononce plugged in, but only for the blink of an eye and then shuts off and the monitor has nothing. I have no idea what the problem is, I do not think it is the same problem everyone else has been having with this monitor, because my light does not stay on like the others.

Your OS is faulty.

Here's some tricks I would try...
1. Verify the monitor's power cord is plugged firmly into the wall outlet and the back of the monitor.
2. Verify the monitor cable is firmly connected to the computer and the monitor.
3. Verify that you have turned the monitor power switch on.
4. If the power light on the monitor is not on, test the wall outlet (plug in a light or something you know works).
5. If the power light on the monitor is not on, try a different power cord.
6. If the power light is on and yellow or orange or flashing, but nothing displays, or the display is incorrect, borrow a monitor from a friend. If that works, your monitor probably needs replaced.
7. Also, you could try your display on a friend's computer. If it doesn't work, your monitor probably needs replaced. If it works properly on your friends computer, the problem may be with your computers video output port, motherboard video chip (or video card, if you have one), or drivers.

Good luck.

Check for back lighting. The screen will glow.
Sound like the power board is out.

Hello.

To power on the Gateway VX750, press the power button on the front. The power button has 3 sides with a "G" in the middle.

The LED indicates the power status of the monitor.

• Not lit - The monitor is turned off or does not have power connected.
• Blinks one time and then goes off - The LED blinks one time when the monitor's power cord is plugged into an AC outlet to indicate that power is detected.
• Lit solid blue - The monitor is turned on and active.
• Blinking blue - The monitor is in power saving mode. Before entering power saving mode, a message briefly appears.

Hope this helps.

that blue light show and error or faulty problem internally or there a problem with in the connection or computer but first check the makers website or manual for troubleshooting.

Yea I fixed it ..bought a new monitor......I tried the old monitor on two other PC's same problem.....

Same here- I understand that the capacitors are bad and need to be replaced. I am going to undertake it myself. Radio Shack sells them.

there are two reasons for this to happen there are blown capacitors inside the monitor and or there transistors on the board that have failed. both can be repaired.

Try this troubleshooting guide it has worked for me in the past 99% of the time http://arstechnica.com/guides/tweaks/troubleshooting.ars