The small dome attachment that connects the lid to the bowl in model 5100 has cracked I need to replace it do you have one?

Firstly, press the STOP button. Then turn the lid in a clockwise direction and lift-off. Carefully remove the blade and inner bowl/bowls (depending on what combination you are using). Finally turn the main bowl clockwise to unlock it from the motor unit and lift off.

try these links for parts

Kitchenaid Food Processor Replacement Parts Accessories Sears PartsDirect


KitchenAid Food Processor Parts


Amazon com Kitchenaid Food Processor Parts


KitchenAid Food Processor Attachment Parts

Contact the manufacturer at their 800 #. You will likely need to purchase a new lid.

For cuisinart food processors that won't shut off: with bowl off - not attached - hold OFF button down while plugging in. With a screwdriver or other implement, press the button that gets depressed on motor base when bowl is attached and snapped into place ( small flat rectangular piece that clicks the bowl into place. While still pressing OFF button, press this a few times times, unplug then release the OFF button. I tried several suggested combinations of button pushing and unplugging, and this seems to have fixed it!

I have the 712 that has everything but the drive pin for the shredder. I also have the manual and replacement parts list. I can't find the drive pin anywhere. I need to either find it or part mine out. Help?

Go to this site. or type magicmix in the search bar at the top of the screen, Good Luck


http://www.magimix-spares.co.uk/Parts-for-Magimix-5100-lid,-...

Cuisinart DCL-7 replacement work bowl lid is cuisinart dlc-017bgtx work bowl lid fitting with large feed tube.

you can go here to get parts.

http://www.maar.com.au/

http://www.magimix-spares.co.uk/Magimix-5100-lid,-main-bowl-and-pusher-/products/1059/

Good Luck and Please Rate FixYa!

I had the same thing happen to me with a Moulinex model 129 lid. Since it is pretty old the part is obselete. I searched the internet and found a replacement part company for small appliances that had my model lid: < AbtecParts.com > and sold it for about the same as the original manufacturer value of the part $10.00. Perhaps they have your lid or you can find a similar replacement company out there. Doesn't hurt to search sites like ebay also where you might find a cheap used one for parts.
Good luck.

My mom gave me her Le Chef that had several cracks in the handel and also the place where the handel attaches to the bowel with a screw was broken. I Used Loctite super glue for the crackes in the handel and a loctite epoxy putty that can be molded into the shape needed to fix the place where the screw attaches the handel to the bowel. After the putty set I sanded it to refine its shape and matched the screw hole in the bowel with the handel then drilled a small polit hole in the handel. I slipped the handel into the slot in the bowl and attached it with the screw and now I have a good as new Le Chef.