Red and green sloop in tv

Install the convergence repair kit for your model. You can get the kit from www.tvrepairworld.com the kit contains the two IC associated resistors and the CD with instructions.

REPLACE STK CONVERGE BORD AND RESITOR 1.9

Youre convergence Ics need to be replaced. post the model number of your set and I will post the STK number that you need and a link where you can get new replacement ICs

The convergence ICs need to be replaced. I can post a link where to get replacement ICs along with free step by step instructions so you can do the repair yourself. Its an easy ,common repair , however a shop will be around 300 to 400

Use remote, sounds like Tv is in child lock

You need to set your convergence. Check your owner's manual on how to do it. I'm not sure the exact procedure on that model, but usually you can find it in the setup menu of the tv. What you're trying to do is line the red and the blue up perfectly with the green so that they all blend together to give you one picture.

Try this, it might be just the thing:http://www.techlore.com/article/15929/Fixing-My-Own-TV/?textpage=3

Closely inspect the board for poor solder connections. Also someitmes the resistors will not show any signs of being bad even though they are open. It is wise to measure them but you need to disconnect the convergence yoke plugs to ge a good reading.

I’m happy to help further over the phone at https://www.6ya.com/expert/dewayne_4a10eab6caecdb92

sounds like your crt tubes...meaning Red, Green and Blue are out of alignment...or possibly 1 of the crt's is burned out.

You need to replace the convergence IC's