I have a baffling issue with my Chamberlain whisper drive. I have noticed that in the middle of the night sometimes the light on the opener comes on for a few minutes. There are no rodents or anything in my garage that could be setting off the motion sensor. What could this be? Paul

Yes but certain brands have been reported to cause range issues with the remotes.. If you contact Chamberlain that have a list of the brands and wattage to use.

Press an hold the learn button on the garage door opener for 10 seconds. You will notice an amber LED either next to or above the learn button. When the LED goes out the anything that was previously programed will be deleted. Now press and release the learn button once the amber LED will come on steady. Now press the button on the garage door opener you want to program to the garage door opener. You will hear a click and the light bulb on the garage door opener will go off and come back on. Your garage door opener remote is now programed with a new code.

If one is green and the other is yellow if they are not blinking, or off. there is no problem at all

It on the back of the opener under the light cover where all of the wires come together.

Have you read the manual, you can find it here Chamberlain Garage Opener Manuals

You can find the user manual here Chamberlain Whisper Drive

The power is not feeding to your opener. Something is either A) wrong with the outlet you are using to power your opener or B) the opener has malfunctioned. Test your outlet to make sure it has active current. If there is any programming issues with this opener, it should have flashing lights at least.

Lights should come on after it starts opening/closing the door. I would call Chamberlain tech support about this.

If you don't have any puppies or strange animals running around your garage I would disconnect the wall control for a couple days. If your problem stops I would suspect that control. If you have a heated garage I would also make sure there is nothing that could be moving from the air movement from the furnace.

You wall control is in lock mode sounds like press and hold the lock button for 3 to 4 seconds that should take care of that problem.

Alleejr your problem is not the same and ill need little more info. Where is the red light on your wall control? If its on the way up its not your sensors at all. Is your spring broke?