Sharp copier ar-5316

That unit uses an AR-016TD Toner/Developer Cartridge. The developer is changed each time you replace the toner. To remove the drum unit open the right side cover, then the front cover, remove the TD cartridge, loosen the green screw on the front of the developer unit housing just above the TD slot. carefully remove the DV unit without tipping or you will spill out the existing DV. Then you can pull out the drum unit. There may be a green screw on the drum that must be loosened but I don't think so on that particular model. Installation is the reverse of removal.

E7-11

To change the developer must remove the toner cartridge then unit development, it has a screw you look at the front, remove the developer unit off then you will see three more screws that need to remove and then remove the drive into two distinct parts, in the front you will find developer. It should be discarded, then put aspiring developer unit again. For the drum, if you have a kit, Katun is the best, remove the cylinder, has a clip on its end to be rotated to release the longing behind the cylinder, remove the corona, it has two screws, then remove blade, it three screws. All you need, if you don't know, is in the service manual of this equipment.
http://www.tradebit.com/filedetail.php/185184978-sharp-ar-5316ar-5320-service-manual

Excuse my poor english.

My copier reports H4. Please give me the solution to this problem.

Sharp fo-2600 fax ld error

Wat iz error code H4-00 sharp AR -M 236

I have a problem with Sharp AR-5316E, the problem is coding problem it is showing that H and 4