Phillips Azur Precice 4340 , lost instructions . How do you de calc it ? Thank you . Claire

Press the reset button

I have a Bosch sensixx b3 iron I have Lost the manual and need to de scale it

Hi
I too had the same problem. I emailed Bosch (via their website and gave them the model number and they have emailed the instructions.
This should have been with the iron in the first place!

thank you solved de scale instructions for Tefal Ultraglide easycord 55, found manual on net....

Calc-Clean function
The Calc-Clean function removes scale and impurities.

To do so, set the steam control to position '0', set the temperature dial to 'MAX', and fill water tank up to the 'MAX' level. Then heat up the iron until the pilot light on the handgrip goes out.

Remove the mains plug from the wall socket and hold the iron horizontally over the sink. Then press and hold down the 'CALC CLEAN' button.

Move the iron forwards and backwards while boiling water/steam squirt from the holes in the soleplate to wash away impurities/scales.

When the water tank is empty, heat up the iron to dry it.

Finally move the iron to and fro on a piece of cloth to dry the soleplate. Repeat the process if necessary

its just connected with a screws on the front flap that has to be opened to seperate it into two parts,and inside there is small black coil thats is connected to the wires that wires must be short so has to be replaced with another wires. do it carefully .take care.

i had the same problem and the Philips hekp site was no use. I turned my iron off until it was completely cooled down then switched it back on again, with the steam number turned to 5 and the heat on max. as soon as the ready light went off, i put my iron in the horizontal position and shook it back and forth (quite vigorously) and it seemed to have dont the trick!

heres a link so you can get more information for your product , hope this helps AJ .

http://www.shopping.com/xPP-irons-norelco~LO-1~CR-0