F&P Intuitive washer IW812 very noisy water

the R.P.S or rotory postition sensor is faulty or the connections are corroded

rotory postion sensor is faulty

Your machine cannot detect correct water level
The clear pressure tube has come off or got a hole in it somewhere.

Reset it by unplugging. Wait a few minutes and plug it back in.

Hi just read your posting.Unless the machine shows an error code the diagnostic mode will not help.Does the machine agitate in the wash cycle?Does the machine drain the water completely?Does the machine spin the clothes dry.Please reply with additional information on the questions I have posted and I am sure I can help you rectify this fault.Looking forward to your reply.

if it keeps filling until it floods the it has afaulty transducing which is locatedin the mainboard which will have to be replace

You need to pull out the washer, TURN OFF THE WATER, then take the water hoses off the back of the washer. Check the screens inside the water inlets for debris. If that doesn't fix the problem you may need to ask fisher paykel if it's safe to put a chemical like limeaway in those holes to remove hard water deposits that have built up inside the valves.

you prob need to get an electronic component in the motor replaced

If when you press pause while filling and it keeps filling then you have a faulty valve. If the filling stops then valve is ok.
If you filling keeps going until overfilling the machine which is what i understand is your problem, then most likely that you have a small pinhole in your pressure tube.

I can talk you through fixing this in live chat