EMERSON 32" LC320EM82S TV. As noted on over 8 pages of consumers complaints, I have developed the same problem on the above TV. Turned it off and now it will not turn back on. Unplugged for over an hour for reset as per manual..no results.
This is production problem and needs resolution. Did Emerson come up with a solution to fix this problem that will be little or no cost to consumer?
SOURCE: Remote code for Emerson SLC195EM82 TV
Here is a list of remote codes for Emerson TV: 004 009 014 023 024 025 026 027 030 032 033 034 035 036 037 038 039 040 041 042 043 045 046 049 053 116 135 147 177 179
Give them each a try (a pain I know) and please rate me if they work!
Take Care,
-WN
SOURCE: Won't turn on
one of the inverter transformers has gone bad replace the bad one and the set will work fine ,there are 6 transformers in the 32".
SOURCE: power cut off and won't turn back on
The board you need to replace is the power supply board. The board# is BA71F0F01042. Your power supply board should have the same number on the lower right side of this board.
The problem is the 6 Transformer Inverters that power up the LCD screen. If one blows out, the TV will go into protection mode like it's doing now. All the Funai TVs are having the same problem. Because, it uses the same parts.
The board is hard to find right now. Only three places I know of to find it.
Ebay,
Discount-Merchant.com,
and Shopjimmy.com
Sadly, nobody has them in stock.
I wish I had a extra board to sell you, because I know how to repair it. I have the schematics diagrams and part# for the pieces on the board.
If you ever come across a replacement board, let me know. I would like to buy your old board. Here's my e-mail, [email protected]
SOURCE: Shuts off automatically after 2 seconds
Hi, you're one of many people with this problem.
The problem is the Inverter transformers on this board here:
You can see 6 of them lined up in the front of the board. The windings in the Inverter Transformer are very small copper wire that breaks easily. My new TV lasted 4 months until this problem occurred. I had to solder in a new Inverter to fix the problem.
The board number is BA71F0F01042.
The board is hard to find right now. Only three places I know of to find it.
Ebay,
Discount-Merchant.com,
and Shopjimmy.com
You can replace the whole board or replace the bad Inverter to fix the problem.
Let me know if you need any more help.
SOURCE: it being emerson 32" hdtv lcd turns on but immediately turns off
This is Emerson's #1 problem.
The Inverter Transformer on the power supply/backlight inverter board goes bad. It's what powers up the screen for your TV. When the part goes bad, it doesn't have enough juice to power the screen and the TV automatically turns off. You have 5 Inverter Transformer on your board.
You can fix the problem by replacing the whole board or replace the bad Inverter Transformer.
Here's where you can get a new board for a good price:
http://www.shopjimmy.com/catalogsearch/result/?q=lc320em9+inverter
Or, here's where you can get replacement Inverter Transformers:
http://www.partstore.com/Part/Funai%20Corporation%20Inc/Funai/LTZ2PC0MS008.aspx
http://www.encompassparts.com/products/?LTZ2PC0MS008
220 views
Usually answered in minutes!
×