No disc loaded warning message

This is a common problem with DVDs. You must not leave them idle for such long periods. Second, you must always leave a disc inside the player. It protects the optical lance from dust. There may be some dust deposit on the lance or the loading rubber belt may have gone lose or the spindle motor which rotates the disc might have gone slow. But to solve this problem you will need a qualified technician. Good luck.

Hi msaslloyd ,


This could be because of a damaged lens , where the dvd player tries to recognize the disc but is unable to do so and then either sends the disc back i.e. the tray opens up or the message no disc loaded is displayed.

I suggest you to :-

1. Clean the lens with a lens cleaner available in the market and load any disc in the player to check if it's working fine.
2. Get the lens replaced from the market and the problem should be solved.

Hope this helps ..:)

I have a Samsung BD-P1490. When I turn is on the display reads "Load." It never displays "No Disc", or trys to play a disc if one is present. I have never updated the firm ware. Any ideas?

i dont know

Use lens Cleaner

please please VOTE ME

you might have a burnt out lens, bring it to a repair shop to have it looked at

Either the disc or the player likely need a good cleaning. Clean the disc with a soft cloth, clean the player with a good cleaner disc.

Are you loading to play or to record?
Commercial DVDs should play.
DVDs for recording may not be recognized by your drive. First make sure that the disc is blank. You must insert a blank disc of the proper format: DVD-R or RW, DVD+R or RW. Even with the proper format, some brands may not behave the same way as other brands.

Dear friend,
It's software problem.software corrupt in ur dvd player flash ic.

If you cleanred the optics and this didnt help then you did all you can do without more test equipment. Your player might need an focus or tracking offset alighnment or a focus or tracking gain alighnment or the unit could have a defective laser. Only by connecting it up to test equipment will a tech be able to tell.