Hello,
Turn the satistical plots OFF
Press [2nd][Y=] (STATPLOT). Select or enter 4: to execute the command [PlotsOff] [ENTER]
Clear the lists (statistical lists)
Press [2nd][0] (Catalog]. Press [PGRM] C. The cursor jumps to the first command in catalog that starts with C (The greek letters in names do not matter). Scroll down a bit to reach the command [ClrAllLists]. Select it and press [ENTER].
Try your graphs again.
If you still have problems, just reset the RAM:
Press [2nd][+] (MEM). Press 7 to select [Reset] then [1:All Ram][2:Reset]. Press [Clear] to erase the Ram Cleard message.
Now you should be able to draw the graphs.
Hope it helps.
Thanks for using FixYa.
If the Transfrm App for dynamic graphing has been used, it remains in memory and takes over some of the functionalities of the calculator. If Transfrm is the culprit, it must be unloaded from memory.
Press Apps, find Transfrm in the list of Apps, select it and press ENTER. The screen should say Transfrm Running 1: to continue, 2: to un-install, and maybe 3:about. Pressing un-install and accepting all subsequent messages will unload app and restore calculator to its innate behavior.
It was the Transfrm App. Thanks so much!! I have the SAT2 tomorrow, this was a lifesaver.
thanks this was very helpful :)
Reset the ram worked, thanks.
If you have a TI-84 plus with the transformation graphing app (transfrm) just open that and select uninstall.
Note: I didn't find this on my own, I got this solution off of the TI-84 plus website.
×
23,203 views
Usually answered in minutes!
×