My Garage door opener keeps losing the codes. Every couple of days I have to reprogram the remotes and the doorpad. This started about 2 weeks ago.

Did you wipe out the codes in it.. It will only hold 3 or 4 code, not sure which.
See your manual, I think you hold program button down ten seconds to wipe all out. Then reprogram. Of course, should not have happened in first place... May be a board problem.

If this does not work you should follow instructions for warranty service. That might be your best course anyway. warranty it, else it may happen again after warranty expires.

FIRST CHECK TO SEE IF THE LOCK/VACATION BUTTON ON THE WALL CONTROL HAS BEEN ACTIVATED. THE LED ON THE WALL CONTROL WILL BE FLASHING. - SIMPLE SOLUTION PUSH THE LOCK BUTTON AND HOLD FOR 2 SECONDS TO TURN OFF LOCK FUNCTION.

SECOND TRY TO REPROGRAM THE REMOTES TO THE UNIT - THEY WILL SOMETIMES LOSE MEMORY IN AN ELECTRICAL STORM.

IF REPROGRAMMING DOESN

This problem was exposed on a popular news program some ten years ago. There's a number code inside the remote that you have to change, and set the garage door opener to the same code. It should solve the problem.

I think your neighbor has a problem. Not you.

YOU MAY HAVE A LOOSE BATTERY CONECTION IN YOUR REMOTE.

ANYTIME THE BATTERY CONNECTION IS LOST (EVEN MOMENTARILY) YOU WILL NEED TO REPROGRAM IT.

IF YOU CAN'T FIND AN OBVIOUS PROBLEM WITH THE BATTERY, I WOULD REPLACE THE REMOTE.

HOPE THIS HELPS

FIRST CHECK TO SEE IF THE LOCK/VACATION BUTTON ON THE WALL CONTROL HAS BEEN ACTIVATED. THE LED ON THE WALL CONTROL WILL BE FLASHING. - SIMPLE SOLUTION PUSH THE LOCK BUTTON AND HOLD FOR 2 SECONDS TO TURN OFF LOCK FUNCTION.

SECOND TRY TO REPROGRAM THE REMOTES TO THE UNIT - THEY WILL SOMETIMES LOSE MEMORY IN AN ELECTRICAL STORM.

IF REPROGRAMMING DOESN’T HELP TRY REPLACING THE BATTERIES IN THE REMOTES AND THEN REPROGRAM.

HOPE THIS HELPS

It sounds like the wall button has the lock feature engauged.

Is there a small green LED flashing inside the wall button?
Push and hold the lock button for about two seconds and the LED should stop flashing. This will unlock the garage door opener and your remotes should start working. You may have to reprogram your remotes and homelink again since you triedprograming in the lock mode.

Good luck.

Check the photo eyes for alignment.

change the security code in the opener and the remote.
seems like omeone in your are have the same frequency remote.

when you are programming , how long do you push LEARN button for, If you push for 6 or more seconds, you are wiping out all code, Push for 1 second to add a remote or keypad,