Wont stay lit - Mr. Heater MH9B Ceramic Utility

Whirlpool oven won't light - Appliance Repair Forum

forum.appliancepartspros.com/oven.../225907-whirlpool-oven-wont-lig...

May 19, 2011 - 10 posts - ‎2 authors
I have a Whirlpool Accubake oven (SF362LXSS0) that doesn't seem to be consistently turning on, and the problem's getting worse. ... If I try to turn it on to bake, I hear several clicks, but not that "gas oven turning on" sound and no heat comes out (but a slight smell of gas is ... Whirlpool Gas Oven won't stay lit
1 post
Oct 25, 2012
whirlpool oven won't stay on
1 post
Aug 13, 2012
Whirlpool Gas Oven Will Not Stay Lit
2 posts
Jun 20, 2012
whirlpool accubake oven will not stay lit
1 post
Nov 9, 2009
More results from forum.appliancepartspros.com

Whirlpool Accubake Model # GW395LEGQ4 - Oven won't Start ...

Sounds like the thermocouple is shot

Do you have a good pilot flame? Is it wrapping around the thermocouple good? You may need a new pilot orifice.

There might be a sensor in front of the burners. Looks like a metal rod. Make sure power is off and carefully use a wire brush to clean the rod. It will only have 1 wire to this sensor.

Propane or natural gas.

there is a small adjustment screw on the gas valve,turn it clockwise to increase pilot,if that does not work the vent cap on the gas regulator on the back of the unit could be stopped up,remove that cap ,clean out or replace unit can operate without it just fine.If you increase the pilot and it still wont stay lit replace the thermocouple

if its lit by a pilot your thermocouple is bad the purpose of the thermocouple it to keep the gas valve open

Blow out the dust from the pilot and reposition the pilot where the flame hits the tip. more

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

call 1800hobart,they are a national chain.

go to this site www dot desatech dot com. Here you'll find parts to repair your heater. a propane heater uses a millivolt generator to sense the flame. along it's cappilary are two push on spde connectors. these connect to the high limit temperature sensor which is mounted on the flame backplate of your heater. to see if it is the high limit shutting down your heater, jumper across the two spade connectors. if the heater stays on, this is your problem. if the flame still goes out, then the millivolt generator is shot.