Need to find inside diagram / for tower-sent out for repair, came back from IT guy. all wires where discounnected system like comes on but nothing happens

ok Ed I found you again and more info , your ignition is point, unless modified style,mallory is a hi out put ignition system ,that gives great spark control,=power goes to coil and is sent to distrubiter to the points to the rotor to the plug wires to spark plugs.NOW you can get any unit of wiring but not the whole car that would take 100 of pages ,or you go and buy a SHOP REPAIR MANUAL for about 125.00 or more what you can do is type in (images of wiring diagrams 1967 mustang (motor size) (and area you need ) ) like ignition ,blower motor,head lights, and look at site ,and lastly join a mustang car club online those guys EAT AND BREATH mustangs and can lead you to all the info you could ever want . I REALLY hope this gives you what your looking for.
Woody

Hi bud do youself a favour before anything else take the main motor out and send it in to a reputable electrical repair co such as dynamic electrical in Benoni or look up a similar co near you and make sure that your system has not been hit bye lightning or a power surge from the supplier first I do own a Co that specialises in evap coolers and from previous knowledge a lot of the new systems have 12V inverters and if there has been a storm and you havnt diconnected your unit the PCs and motors are more than likely fried

Trail and error is your best bet cant really hurt anything.... odds are you wont find the diagram

They have several docs. Here are two pages that might help.


http://support.dell.com/support/edocs/systems/dime521/en/SM_EN/techov.htm#wp1053345



http://support.dell.com/support/edocs/systems/dime521/en/SM_EN/parts.htm#wp1043338

What is the yellow wire for comes from right side of frame and runs back towards the battery but I'm not sure where it plugged in at.

go to www.toyota.com/help/. these guys help they sent me a diagram for wiring my backups for 1997 toyota cramry

its the mane box in back of computer that the mane tower cord plugs into.

in 15pin connector of the monitor,
red wire goes to pin No:1
green wire goes to pin no:2
blue wire goes to pin no:3
yellow wire goes to pin no:13
white wire goes to pin no:14
and black wire goes to 5&15. Now display will come!

Blinking amber ... seems like an isuue with the power supply .. check if you see the power supply fan spinning at the back of the system tower... If its spinning then you could try reseating the memory modules inside the system tower . Opem the tower and then disconnect the green colour ruler shapped modules which has a latch on either sides. then try turning in the system ... check if turns on properly.

Hope its informative.

see if one of the little wires inside the wire end from the monitor that goes into the tower is bent or messed up. If one of those are missing, the whole monitor is messed up. Also look on the back of the tower for the |O| picture. It should be blue.