Need replacement cage (around windscreen) for sennheiser e835

Some the head of the condenser spins off counter clock wise, if it just spins there is a very small set screw to release, the wire connections are within.... hope this helps?

If the microphone is ballanced there is no problem. Only XLR unballanced would be a problem.

Always start with flat setting. Be careful of boosting highs as feedback may be a problem Put the speakers forward so mics can't "hear" them.

Phantom Power (or an internal battery) is needed to operate 'Condenser' type microphones.
The E835S from Sennheiser is a 'dynamic' microphone and, as such, does not require any power source for it to operate.
If you are using several different types of microphone together (dynamic and condenser) it should be quite safe to have phantom power on - it won't cause any damage to the Sennheiser.
However 'ribbon' microphones will be destroyed by phantom power

The 1/8" input is expecting "line level" for the audio. The mic generates "mic level" which is much lower. In order for this to work as you'd like, you need to have a mic preamp in the system. The typical way to do this is to use the output from a mixer rather than from the mic directly.

Dan

Hi, after checking the wire and no damaged,it means that the speaker itself is damaged.You can replace it if can get a spare around repair stores around you.


Thanks for using fixya...

Try this link.  http://www.sennheiserusa.com/serviceandsupport?00002

The cartridge is likely damaged, probably fatally.

Try to open carefully and see if windscreen MIGHT be hitting the diaphram.

how long did you hold the on button for? press it longer

it is very good brand first try to get ride off humidity and wet by putting it with some rice in plastic box and leave it for a couple of days(rice absorb wet and humidity).if it is not working good change the mic capsule.