I have a Mitsubishi medallion 65'' big screen, model ws65411. It turns off by itself. I can turn it back on after a few seconds and it might stay on a few hours or a few minutes. What's the problem?
Dear Sir,
This model is equipped with a self-diagnosis feature to help with diagnosis of shutdown problems. To activate this turn the unit on let it shutdown then press the input and menu buttons on the front panel simultaneously and hold them in for 5 seconds after 5 seconds the power LED on the front panel will blink a two digit sequence. This will be one set of blinks a short pause then another set of blinks, this will repeat 5 times.
1 - 2 = no error detected
2 - 1 = X-ray protect (high voltage or beam current)
2 - 2 = Short protect (short protect monitors low voltage supplies)
2 - 3 = Deflection protect (this could be loss of vertical or horizontal deflection)
2 - 4 = Vertical protect (usually loss of vertical from the source)
1. SHUTDOWN AT POWER WITH SELF DIAGNOSIS ERROR 2 2. CHECK FOR OPEN FUSES F9A04 PART # 283P044020 AND F9A05 PART # 283P043090 ON THE +24 AND -24 VOLT LINES. IF THE FUSES ARE OPEN THE CONVERGENCE OUTPUT CIRCUIT WOULD BE SUSPECT. I hope this helped.
Good Luck, big IRISH.
redid diagnostic. got new code 2 blinks pause 3 blinks repeats.
I got 2-2 problem code, but I checked the 2 fuses are ok, less 0.1 OM.This problem was happened suddenly when I watched the NFL football today. Please what solution to solve this problem. [email protected]
I got a 2-3 on the code? what do I do to fix the problem [email protected]
×
2,049 views
Usually answered in minutes!
×