I can't get my TV on channel av. The remote doesn't work. I need to program AV on the tv menu.

on your tv go to menu & somewhere there it will say scan for channels so it will scan for about 5 mins then grab your remote & turn to channel 73 & there you go . if not try moving the tv to a different source like AV or YDRB

Hi -

If you have a cable TV line connected directly to the TV, an antenna or a cable box connected by coaxial cable, I would suggest running the automatic channel scan (AUTO-PROGRAM) again:

1. Press the AV key on the Advent remote control repeatedly until TV is displayed in one corner of the TV screen. If you don't have the Advent remote, use the TV/AV button on the front of the TV.
2. Press the MENU key on the advent remote or the front of the TV to open the on-screen menus.
3. Use the CH+/- keys on the remote or on the front of the TV to highlight PRESET then press VOL+ to select.
4. Use the CH+/- keys on the remote or on the front of the TV to highlight ANTENNA then use the VOL+ key to select either AIR (for antenna) or CABLE.
5. Use the CH+/- keys on the remote or on the front of the TV to highlight AUTO-PROGRAM then press the VOL+ key to start the automatic channel scan.

Once the channel scan is complete, the TV should automatically return to viewing the first channel found during the scan. Do not press the MENU key during the scan or the scan will not complete.

If you are using a cable/satellite receiver and it is connected to the TV by any means other than a coaxial cable, you do not need to run the channel scan. You should simply select the correct AV input using the AV key on the remote or the TV/AV key on the front of the TV (see step 1 above).

If you have done all of the above and you are still unable to get the channels on your TV, please post back for further assistance. You can reply to me by clicking on "Add a Comment" below your question. Please let me know whether you are using a direct cable line, antenna or cable box, etc.

Regards,
BElectric

Hi mate,

You need to get onto your AV channel. The button is on the remote control but since you don't have one, this could be quite tricky.

WHy don't you try going onto channel 1 and then pressing the button to go down or back a channel (usually P- or C/CH-) as quite often this will move you onto the AV channel.

Try this! Get into the menu and look for channel setup. See channel memory delete or save and add this to channel memory. Hope this works..I never repaired this model. This is only a suggestion.

change channel up/down to AV or Input. To get this to program in the channels, you will have to turn on dvd, then go to tv menu and select "autoprogram" and it will search all available channels including AV/Input

did you try the av button on remote

If you want to get the original remote for this model (AV-30W776), you can find it at this JVC parts ditrubutor:

JVC AV-30W776 Replacement Part Remote Control

MENU ...... PICTURE ..... TURN GAME MODE ON ..... EXIT MENU ...... TURN TV TO CHANNEL 3 or 4. THIS WORKED FOR A GAMING SYSTEM AND MAY RESOLVE DVD CONCERNS ALSO.

FUNAI ............. WWW.FUNAI-CORP.COM SERVICES DURABRAND.

I dont know if you tv has this sertting but click menu usally 4 times and it will bring u to a page wich might say channel or something else and u can chane the channel by using the volume buttoms this worked for me and i can put it onto av1 av2 av3 and av4

Hi, If the AV button is not in your remote, then perhaps it is part of the Ch up/down buttons - meaning right after your last programmed Channel would be AV before the first program Channel. Although I have yet to come across such a case, I have worked on units/remotes that have this feature of the AV included in the channel memory. Good luck and kind regards.