E10: No cold fill - check that the cold inlet tap is not turned off, or the inlet pipe is not kinked.
see think link for detailed link..
Sometimes
intermittent FALSE errors like this can come up if there are high
resistance (oxidised) contacts between the ribbon cable that goes from
the POWER CARD to the facia panel electronics. To fix that sort of
problem, remove any retianing clips from the end that plugs into the
facia panel, remove and replug the cable end a few times. This gives
the contacts a “wip-clean” action and can remove the oxide. Obviously
if the cable or contacts are badly corroded or burnt, then replace it.
Here are a few more error codes of interest:
E10 - not filling
E20 - not draining
E40 - door open
EFO - Filter blocked
what happnd??
×
Http://www.manualshark.org/manualshark/files/5/pdf_10516.pdf
pages 31-32 for e10 e20 codes. if you are sure you have cleaned the drain out fully and that your water tap is fully on, the next thing i would do is check the level of the machine. If thats still not it let me know and ill try to give you a few different ideas before you pay someone else. Is the machine emptying all the way? Is it emptying slow? anything like this? could be a drainage problem on the outlet of the hose. let me know if this helps.
Hi,
If the fault code E10, E20 or E40 is shown in
the multi-display, you may be able to remedy
the fault yourself
After clearing the fault, press the START/
PAUSE button. If the fault code is displayed
again, contact your local AEG Service Force Centre.
Here is the fault remedy:
The fault code E40 appears. The display MAIN WASH flashes.
Then The door is not correctly closed.
Close the door correctly.
Start the programme again.
Goodluck,
Please don't forget to rate me as fixya..
The trouble with that darn E20-error, is that it might refer to any blockage in the water supply. So cleaning the pump is usually a first, but it might also be a blockage in the soap tray (when available), the tap or the hose attached to the tap. Since it returns every 3 months, it seems most likely that the real cause is somewhere you clean less than the pump.
If you say the pump is humming but not turning I guess that that you have ckecked this by opening the back of the machine. If that' s the case than there is something wrong with the pump. Have you tried to open up the pump and turn it by hand afetr such a trouble?? It can be a bad bearing or a not proper functioning e-motor. Did you check also the outlet of the pump?. Are there no blockages to the sewage canal?.
E10-This code usually means that there is no cold fill. If the cold isolator tap has not been accidentally turned off, then most likely the clamp-on pipe (see previous FAQ) has corroded over time and needs changing to a proper isolator valve TEE. The other possibility is that the cold-fill valve has failed. This is the unit that the cold inlet pipe attaches to at the rear of the machine.
×
Easy solution, your pump filter is blocked. There is usually a tube behind a panel at the bottom of the machine, undo this and drain into a suitable container, then unscrew the drain plug and clear the blockage (usually fluff or sweetpapers!). This is probably in your handbook under emergency emptying/drain pump clearing. Beware lots of water can come out!!
708 views
Usually answered in minutes!
×