I have a MDE 7500AYW Magtag Neptune Washer that came back with a sensor off message or something like that my mother said but I don't have the plug attached to find out again. She said it would run for a couple of minutes and then cut off.

check door inter lock

If you want to DIY the issue Google "Sticky: Neptune TL Washer FAV6800AWW" you can get the Service Manual from that site to help you DIY the fix along with forum guidance.

I discuss the troubleshooting the Left Hand Lid Lock in that sticky.

I can't find my repair notes on this forum no Sticky and no Service Manual.......D*ick

Hi


Its available for $213 and 219 with different dealers. Please check these links for more details from where to buy--

Maytag Neptune FAV6800 Control Board Link 1

Maytag Neptune FAV6800 Control Board Link 2

Please post back for any further assistance.

Daniel

The LL error code is not documented very well.

Can you tell me what point of the Wash Cycle the Cycle Status LED is in when you error out with the LL error code?

I believe it will be in the Spin Cycle of the wash cycle.

You could try a Quick Spin test and see if the wash basket will spin up to 850 RPM with no laundry in the Wash Basket. See Page 14 of the Service Manual and see if the Wash Basket will spin up to 850 RPM.

You could also check the TDS for proper range of motion using the SM or this typed out process.
Tub Displacement Sensor Diagnostics check.
It is possible the Tub Displacement Sensor may have failed try this check which is in the Troubleshooting guide stored in your washer console or refer to the SM.

a. Enter the Service Mode by pressing and holding the Enviro Plus and Spin Only keys for three seconds or the display reads “00”

b. Press the Super Wash key display reads “in”…something like that.

c. Press Delicates the Display will show “UC” (Unbalance Closed).

d. Push tub to the back right corner of the machine the display should change to “UO” (Unbalance open). Release tub and the display will show “UC” (Unbalance Closed).

e. Press Hand Wash.

f. Pull tub to the front left corner while pushing the tub down the display should change to “UO” (Unbalance open). Release tub and the display will show “UC” (Unbalance Closed).

If you fail this test it would be time to remove the machine front cover check if the TDS sensor has fallen of its mounting position between the Tub and the washer frame.

might need the mother board

your un-balance switch may be getting bad/loose,need part # AP4027385 by whirlpool

u just have to take the screws out and flip everything around

http://www.pcappliancerepair.com/model-display.php This one looks like a real puzzle. Open the door and look for screws holding the front on, the top seems to lift up once something is released.

My dyrer just stopped working one day. I've had the heating element checked, both boards and my electrical outlet checked but my dryer still doesn't work. All I get is a troubleshooting code that looks like an upside down F with a 5 behind it. If you have a solution to this problem please let me know Thank You.