Ricoh aficio cl7300 error sc542 what does it and how do ifx it

hi

SOURCE: ricoh aficio 2022 error code sc542
1. Mode(Yellow Button)
2. 107
3. Press STOP Button for 3 second (RED Button)
4. Copy Sp
5. 5810#
6. Excute
7. Power Off
8. Power On

Ricoh Aficio MP2510, 3010 Error code sc542 on Lanier ...

? 6:08
https://www.youtube.com/watch?v=58MQVyjfDyg
Sep 3, 2013 - Uploaded by Used .Copier
Are you getting Error Code sc542 on your Ricoh, Lanier,Savin or Gestetner copiers? ... Ricoh Aficio 1022 ...

How to reset Ricoh Error Code sc542 sc546 sc548 problem ...

? 2:41
https://www.youtube.com/watch?v=3CnGl1Ytp34
Sep 21, 2015 - Uploaded by Copier Liquidation Center
How to reset Ricoh Error Code sc542 sc546 sc548 problem ...Ricoh Aficio copiers : AFICIO 1013 F

Found you a procedure:

Thread ricoh aficio error code SC542

This is the correct solution to resolving SC542 error on a Ricoh SP3410 SF and SP3510SF:
Press Clear/Stop button once and then press 1 0 7 and then the Start button to enter the "Engine Maintenance" in Maintenance Mode. Select "Fuser SC Reset" and execute..press ok. Turn main power on and off. Issue will be resolved.

thermal fuse blown this guy says


Ricoh Error Code SC541 sc542 sc 543 sc544 sc545 sc546 Lanier Savin...

Ricoh Aficio error SC542

Look at the transfer unit. If the clear belt has alot of wear lines the belt needs to be replaced pn# B180 3780

The machine builds the alignment image on this belt and then reads it if the belt is cloudy it will fail.

sc 541=Heating roller thermistor error (Fusing unit).
The thermistors could be dirty or damaged.
The fusing unit can be removed and inspected(without removing any screws)(Left door)(lower handle).
If you see any damage you might have to replace the unit(or only the part if u r lucky).

SC542 means that the thermistor hasn't detected right temperature in given time.

Often you only have to reset service code.




Try this reset:

• Press and hold online + escape, then power on.
• Use up and down arrow keys to select SP2
• Press Enter
• Use up and down arror to locate SP5
• Press Enter
• Use up and down arrow keys to select 810
• Press Enter
• Confirm the selection
• Power off and on.

from http://www.fortc.com/2007/06/17/ricoh-cl4000dn-error-code-sc542/ here is another service procedure:

• Press Mode(The Yellow Button)
• Enter 107
• Press STOP Button for 3 second (RED Button)
• Copy Sp
• 5810#
• Execute
• Power Off
• Power On

developer unit not set properly.
push the unit in tight