How to reset Waterfilter light On Model JCD2389DT Jenn Air

WATER FILTER CHANGE REMINDER

(Select Models)

For some refrigerator models featuring

water filters, the Water Filter Change

Reminder function monitors the life of the

filter and provides a reminder when it is time

for the filter to be changed.

When the system detects either 12 months

of usage, or the filtering of 416 gallons of

water (whichever comes first), the CHANGE

FILTER indicator light will illuminate. This

indicates that the water filter should be

changed and the light reset.

To reset CHANGE FILTER light: Press and

hold the LIGHT and LOCK pads until the

CHANGE FILTER light blinks (approx. 3

seconds). The control is now reset for 12

months or another 416 gallons.

Note: The Water Filter Reminder will

operate if the filter bypass is in place.

If you have other questions please let me know, Thanks Sea Breeze

should be a reset button on the door by dispenser.

Read the manual on how to reset it. It makes no difference anyway as it turns on on a timed basis only.

I believe your new Jen-Air has an old model number placed above your post. If you had a newer model nuber I could see if changes were made to the solution. The ods are no changes. I it possible you may have missed removal of te flilter plug? It also is your first time and to press the 2 buttons at same time for 8 to 10 seconds may be a little confusing. I bet after this time you will have this down to an art! here is what I could find without the vorrect model number if that is what happened or not.Jenn-Air
Press and hold the light and lock buttons until the change filter light flashes.
It is very easy to reset your filter indicator light on your Maytag refrigerator. Simply press and hold the light and lock buttons, on the dispenser, for about three (3) seconds, until the change filter light blinks.
Jenn-Air Refrigerators - Press and Hold The Light and Lock Buttons until the filter light flashes (usually 5-10 seconds).

Look for a reset button on the back--push to reset. If trips again, unit has probable short.

select waterfilter from the menu and select reset the change waterfilter message will not be there anymore i have the upgraded model the ekv 6600.1m

On my Fridge you press and hold the reset button for 3 seconds if that dont work has the filter been replaced?

have a good look at front to see reset??.press it once it comes back on unplug from the wall and & open it up and go to the part and give it a good clean with wd40, check the push pad for ware & tare dirt gathers and builds up

Dear mikeyflash01

You said, Jenn-Air jcd2389dt Side by Side...
What is the situation?

Huuum

you may have lost a leg of your 240V service. make sure you have 240 to the appliance and then start chasing down where you lost it. there is no onboard trip or reset on this unit