Hi,
In my college recently we networked the whole campus using utp cable.The problem now i m facing is.we have a general hub at each department block.I have a lan cord from that hub to my pc.It works fine with server's IP setting.When i tried to connect it to a another(Tp1008c) hub and connect three more pcs to it with .I m not getting any network link.Especially i need it to access net.All my pc which i need to connect are running vista...
It is due to connectivity problem pls check the connection
Hi,
use cross cable to interlink between hubs (ex. from hub1 to hub2 & from hub2 to hub3 .... and so on...)
use straight cable to interlink pc to hub
thank you,
Allan
Hi,
Check the following:
Hardware First: Is Vista confirming LAN connection onn that PC, or is it showing disconnected cable?
Is the connection properties showing at least 100Mbps?
Are the RJ45 terminals okay?
Is the driver for the network card recognized by Vista and loaded?
If that is fine, then check the following in the network properties:
1. The IP address you are using
2. The gateway address: it must be the same as the gateway address in the other PCs accessing internet. Run and check
3. The Subnet mask. Use 255.255.255.0
4. HAve you Setup the Nework using the Setup Wizard, including Access INTERNET THROUGH A HUB THROUGH ANOTHER COMPUTER ON MY NETWORK?
Check those things and let us know. Ask for help from your network administrator about correct IP addresses on that LAN
395 views
Usually answered in minutes!
the same here
i am unable to connect my laptop (using Vista) with my desktop computer (using XP) through broadband network. I need to use printer with my laptop.
×