Hoover HNL 662. 'Delay start' light comes on and stops machine

Turn it off at the mains. Leave it an hour and start again.

Here is your manual in case you need it

https://www.manua.ls/hoover/hn-6135/manual

and even a 1 hour video :>)

Hoover Nextra HNWF6135 Washer Dryer - YouTube

https://www.youtube.com > watch

1:03:21 this is another of your choice! hoover nextra doing a cotton 40. please take a look at my amazon.

Its not an error it means its in delay start mode. Hold down the delay start button (looks like a clock) for 5 seconds and it should clear

FLASHING what ~ please?

It is your control board that has failed. It is time for a new machine. It is a common problem. If it's under warranty get it fixed but the machine is starting to wear out.
Unplug and wait for a clicking sound this will be the electronic door lock releasing.

Hi, had same problem the filter was blocked again. It needs to be regurly cleaned out.

Hoover (Nextra series) washing machines

The 'Start' & 'Pause' LED's will flash together to indicate the error code. You have to count the flashes within each 15 second period to get that error code. The start and the pause LED's will flash together at 1Hz (i.e 1 flash per second) within that 15 second time frame, then will continue and show again within another 15secs and so on.

1 Flash = Interlock fault
2 Flashes = Fill time-out
3 flashes = Drain time-out
4 flashes = Overfill fault presure pipe blocked
5 flashes = NTC error
6 flashes = faulty control board
7 flashes = Motor jammed
8 flashes = Tacho fault
9 flashes = Motor triac on module board
10 flashes = Prog Selector or wiring fault

clean out the pump and sump hose

have you tried cleaning the filter at the bottom. remove the front plateat the bottom and there is a small round plate at the left. this has a screw in it. when you have removed this you give it a twist. a bucketload of water and gunk will come out. i found about 60p in 5's but when it was all removed it started to work again

hi there,

make sure that the program is not on the "Intermittent Agitate Program". that would be the cause of the delay.

the other issue would be the timer itself. the timer is mechanical, so once the contact on it is corroded, it will only function intermitently or not at all.

please let me know if i can be of more help.

thanks