Kyocera Mite KM-1510 printing on half pages instead of full pages

There's probably a time piece of paper or something blocking a sensor or pressing down on an actuator or something
try checking this then do a good clean of the unit.

Mite be a problem with your doc feeder. Are you using a doc feeder? If so raise up the doc feeder and place an orgnial on the big glass instead of feeding the orginal thur the docfeeder. Does the line disappear? If it does then the **** glass the small glass used by the docfeeder has a mark on it or dirt. Is your machine a printer also? Does the print have the mark/line on them also. Do any of your machine's internal reports have line on them Meter Read print outs etc.


Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

I have The Km C2520 with the same C6020 code. Is the solution the same?

Co6 mean your copier heater lamp is burning.so you change your copier heater lamp.

Just hold down the stop/clear button for 3 seconds..

It will flash F24 then 3 increments then 3 more.. eg; F24>063>123

It means you have done 063123 copies/prints..

c610Bitmap (DIMM) problem

Laser unit diode is not working. Replace laser unit

check the exp.lamp . it mzay be blinking at the time of scanning the original.

dependds on what the problem is and $ of repair ??????????????

here is the code, not sure what it means

http://www.unitedtechsonline.citymax.com/page/page/4760785.htm