Not spinning while doing the wash

Hi Adrianna,

Perhaps you have washed too big of a load causing the motor to lock up.

This is from LG:

"An LE error code on the washer's display indicates that the motor is locked, possibly due to a heavy wash load.
Large and heavy sized loads will put a strain on the motor, causing the LE code to occur. Performing a reset on the washer will normally resolve this error with a reduced load size. But if the error code displays on every washing cycle, the unit will require a repair service."

Have you tried restting the machine?

https://www.lg.com/us/support/help-library/le-error-code-CT00000305-1337701712239

If you have done all this, and still not working, will probably to call a repairer to come out and have a look at your motor.

Hope this helps!

Kevin

Use your anti crease button and remove the clothes immediatly after spin

1st check ur floor level if the floor level is not flat means sure the error will come.. and dont put a blanket with other clothes

Hi, I beleive there is some damage to the pump impeller or motor.
Check and clean out any debree in intake lines. Then seek help from repair man. Good luck.

Most likely the cylinder is misaligned, if its still under warranty, send it in, if not, this is probably the most expensive fix on a washer. Wouldn't be unreasonable to get a new one.

does not sound good. if you can remove a cover on front bottom or on the back you may find a broken shock, or counter weight, either would need replacing before running again

Sounds like an off balance load. Happens mostly with small load with one heavy item like a cotton sweatshirt.

Hi,

Problems with a washing machine not spinning or not draining are often inter related..

If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing machine not draining and or not spinning


heatman101

Sounds like it's scraping against your heater element.Remove back panel then remove heater element(two prongs with nut in centre)you will be able to see signs of damage if so that will have to be replaced. £20 - £30.00p. Your either overloading your machine or your bearings are have gone, to check bearings pull inner drum while holding outer drum if get movement and knocking they will also need replacing.

The heavy jacket prevented the washer from spinning at a rapid pace, so I added a heavy bathrobe to absorb some of the water and to balance the load. The washer then spun very quickly and drained out all the water.