Kyocera Printer error - Help!

LSU cleaning motor error

When the LSU cleaning motor

is driven, an error signal is

detected continuously for 1 s.

Defective connector

cable or poor

contact in the connector.

Reinsert the connector. Also check for continuity

of the connector cable. If none, replace

the cable.

I think that you have used the lens cleaner and then have not pushed it all the way back in.

Clean waste toner,Drum blade.

close the back cover... or if its broken tape it down...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

you are overcomplicating it... all you need is a compact flash card big enough for the firmware... then you upload the firmware to the card and stick the card into the printer... but first power down printer and plug it out and then turn it on and follow the display... it will prompt you

here is the steps...

you will see ready
then press menu... arrow down to memory card
press forward arrow
you will see format
press enter
you will see processing
when its finished
you will see ready...
turn off machine... unplug it...
pull out compact flash
plug machine in
turn it on...

the **** for the compac flash is on the right hand side at the bottom by the ventillation opening...


I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

the charger is broken...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Push in the charge corona assy. Its behind the left door. Each color has a cleaning rod and charge assy. I've seen this more than once.

Generally it means you need a new developer unit.

Replace the developer unit and that will fix it.

Go to www.kyoceramita.com and you will see a download centre. You can download the driver from there.