Clear print job on Zebra printer

If using windows, using explorer go into windows system folder/spool/printer clear the contents in printer.

disconnect printer from computer and power on again. at driver chech if still jobs there and clear buffer. at printer, if still printing whithout connested its becase it still have information to print. just reset printer to factory default or let job to finish.

You can download one direct from Zebra at
http://www.zebra.com/content/dam/zebra/manuals/en-us/printer/xiiiiplus-ug-en.pdf

Yes this is possible. The PN# is G46999-0801 for Cyrillic Font CG Times.

There is no minimum lenght specified in the manual for this model. There are maximums however.

The manual can be obtained from here:

http://www.zebra.com/id/zebra/na/en/documentlibrary/manuals/en/printer_manuals/xiiiiplus_rxi_user_guide.File.tmp/13383L-004_RA_XiIIIPlus_UG.pdf?dvar1=ProductLiterature&dvar2=XiIIIPlus/R110Xi/R170Xi User Guide (en)&dvar3=46

Hope this helps,
Dan

Try adjusting your printhead. If that doesn't work you might need to replace.

Please contact me if you have any question or if you come across needing a printhead for your unit.

I carry all parts for that printer in stock .

Thanks

Rory Cardenas
Midrange Repair and Parts
Alsip IL 60803
708-597-4222 x240
[email protected]
AOL IM: RORYMRP

As the previous expert has stated, with the printer paused, press the cancel key to cancel the job. One thing to note, is depending on how your software sends the print jobs, you may say print 1000 labels, but the software sends it one at a time, so basically you have 1000 print jobs in the printer. If you pause the printer, press and hold the cancel key. Hold it for about 2 mins. This should clear the buffer.

Did you design the label? Do you have any control over the label design? This is usually a sign that the printer is trying to excede the page limit (usually by one dot row) and is going to the next label to finish. By making the label length slightly smaller, you can stop this.

Don't forget to rate this.

You can download Zebra manulas from here. https://www.zebra.com/id/zebra/na/en/index/service_support.html here is a section of the calibration you require. Sorry it will not allow me to attach. i think issue with site usage.

Anyway press PAUSE to pause printer. Then find & press CALIBRATION, it will ask when you want to calibrate either at power up or after the print head is open & closed. I would select Power up since when you change lables out you should do so with printer off.

Good luck, post any questions to this & also rate it.

go to printer driver properties.. 1.click printing preferences set it to USE PRINTER CONFIGURATION 2.go to advance click Printing Defaults set it to USE PRINTER CONFIGURATION
you must set this two configuration note: fresh installed driver defaulth to software control