Kenmore Ultra Fabric Care Heavy Duty 80 Series washing machine (Model # 110.92389200; Serial # CF 1122814) went through the wash cycle completely, but rinse not the rinse cycle. Motor was going but washer not spinning. Also smelled something like burnt rubber. Could the belt have gone out? Is this something that I can fix myself?
This can be one of three things:
1. The pressure switch / level control
2. The motor / motor switch
3. The timer assy.
4. The lid switch is not functioning.
The most probable suspect at this time would be the lid switch. As you just open or just close listen for an audible "Click" of the lid switch. If there is no click you will need to have the lid switch replaced. Note: The unit will not agitate or spin if the lid switch has failed.
You did not mention if the unit would drain and spin or not. That information would help in isolating the problem. Also the exact model number please. Example (110.XXXXXXX)
If it drains and spins then the most likely suspect(s) would be:
(in order of precedence)
1. The pressure switch / water level control.
2. The timer assy
3. The motor
All of the above 1, 2 and 3 would have to be troubleshot with a meter before replacement.
Thanks for using FixYa.
Kelly
Hi,
If your washing machine will not fill, only hot or cold will fill or is slow to fill then read these tips. I have covered many of the things that can happen in these tips...
Washing Machine Problems No Water
Washing Machine Fix Washing Machine No Water
heatman101
Hi,
If your washing machine will not fill, only hot or cold will fill or is slow to fill then read these tips. I have covered many of the things that can happen in these tips...
Washing Machine Problems No Water
Washing Machine Fix Washing Machine No Water
heatman101
459 views
Usually answered in minutes!
×