My GE Profile Harmony dryer wont dry clothes

Frequently there's an obstruction in the vent duct from the dryer to the outside of the house. For the dryer to heat properly, the duct must be clean and clear of lint or any other substance. Your dryer has some internal ductwork. If it gets clogged, your dryer can't dry properly. In most dryers, to get to the internal ductwork to clear the clog, you have to substantially disassemble the dryer. A quick way to check for internal clogs is to remove the lint filter and use a flashlight to inspect the inside of the duct.

drum roller,drum glides, or idler assemblage which is located next to motor(might be motor going out). Here is a website that will help:

for glides/roller: http://www.partselect.com/dryer+dryer-tears-clothes+repair.htm

for idler/motor: http://www.partselect.com/dryer+dryer-wont-tumble+repair.htm

I finally had a GE authorized tech come to our house, because we've had the same problem on and off for about 2 yrs. Our's is 5 1/2 yrs old, and the problem was the blower motor, which is hard to get to, and the nut holding the fan in place is also put on going the "opposite" direction. (So lefty loosey, righty tighty doesn't work for this one) The Tech told me in all his years he has never replaced a heater in any of these, and it has 2. The usual problem is the blower motor has gone bad. It's working great now, and it was $470 to fix, but still cheaper than a new one....

check out the ignition spark ignitor
that makes the burner to heat up

Heating problem is most likely caused by one strand of your heating element is burned out. Heating element will have to be replaced if that's the case. Noise you are hearing is most likely coming from worn front and / or back bearing. Dryer has to be completely disassembled for either repair.

MAKE SURE THE VENT TO OUTSIDE IS GOOD. IF SO, CHECK THE FUSE, COILS, SENSORS INSIDE THE MACHINE

[email protected]

If blower isnt working you wont feel any or very little heat in the drum

the inertia switch on the shaft of the drum motor has failed This will require removal of the drum motor

Check your email

Possible Solution...
When you get message first try turning off. Open door spin drum one or two times. Close door. Power back on/start.
Works for our problem. Post if this helps.