How much is gestetner 3222 worth

i do not know what machine you wait to reset the fuser code and the service code it has S.C but to enter the servie mode you press (star-107-#) then mode enter then check where scrol you find where its says error reset

Hello!
You have a very old machine...
Assuming that you are putting the right bottle... It could be several problems.
Faulty clutch.. faulty toner supply unit... faulty drum Unit...
The best advise i could give to you is to call a technician...
See you

Hi. I Have new condition Gestetner 400. in Hungary

i search very hard but i dont get the manual in french but i get it in English
go to the link below to download
http://www.retrevo.com/support/Gestetner-DSm415f-Copiers-manual/id/21435bh126/t/2/
click on get manual & download it
hope it resolves the problem

Most machines just use regular or notebook hard drives available anywhere.

Just replace & format it inside of the copier menus.

Sounds to me that the paper tray is set incorrectly. There is a dial on the back of the machine that needs to be set correctly once the paper tray guides are adjusted accordingly -particularly when running 8 1/2 x 11" (letter) size paper. It can be set to run either lengthwise, or laterally (portrait) make sure the dial is set to the proper setting on ALL trays. If the tray is set for lateral, for example, and the paper is installed lengthwise, the scanner only utilizes 8 1/2" in length rather than the full 11". Frequent jamming is also a common problem when making multiple copies, because the paper is not where the machine "expects" it to be. Also check that the LCD display reads the proper size / orientation after adjustment.

Hope this helps. Please rate solution :)

Use Ricoh equivalent af220 or af270 when ordering.

What model gestetner is it? There are different ways to rest it. What generation are you talking about? 10 years old or two days old model?? Need some more info. The problem may just needs to be rest, it most likely a fuser code to cold or to hot.

When you put a new cartridge in I take it you have removed the black cap that sits on top of the toner bottle (if you haven't remove it) The machine as default allows a 15 second gap from when you open the door and put the cartridge in to when you close the door. If you are too fast at changing toner open the door wait 15-20 seconds then close the door . Machine will then show on the control panel that toner is loading. If this does not work repeat two more times if still does not work then the drum unit (Photo Conductor Unit) is not accepting toner you will have to replace it.

Hope this works
J

I take it that you removed the black cap on the toner bottle OK thats out of the way open the door remove the toner as you would to replace. Remove the toner bottle look inside the bell behind the green handle and check that you can see a claw type thing if you cannot remove obstruction. Refit the toner close door and wait until machine stops and see if toner light goes out. If not open door wait 15 seconds close door and machine will start loading toner again. You may have to do this 5-6 times if it doesn't work after this then likely thing is the toner motor faulty and will need replacing

Thanks J