Westinghouse sk-32h540s TV, VGA input, image can't center.

No, unfortunately not. There is no internet connectivity to it. It was released in August 2010.

http://www.hdtvsolutions.com/westinghouse-sk-32h540s.htm

and the manual is here

Westinghouse SK-32H540S LCD TV User Manual - HDTV ...

http://www.hdtvsolutions.com > 206_User_Man
PDF
E If the interference persists even after performing the above measures, consult the Westinghouse Service. Center or an experienced radio/TV technician for ...


..

Possible parts:

http://www.shopjimmy.com/westinghouse/sk-32h540s

User manual:

https://www.manualslib.com/manual/266852/Westinghouse-Sk-32h540s.html

There should not be a driver required for this. As long as your HP desktop has a VGA video or HDMI video output, you can connect to the back panel of the TV from the video port of the PC. Then, on the remote, select the "PC" option for VGA input, or HDMI for the HDMI 1 or 2 input(s). If the PC only has DVI output, then it is important to know if the output is analog or digital. If it is digital (DVI-D or DVI-DD] then there is no available port on the TV to support it. Using a DVI-VGA adapter on a DVI digital output will not work as there must be a digital-to-analog conversion in order to work.

if older tv check caps in power supply.

Dear Amy,

Normally, monitors do not have tuning electronics for capturing TV signals.
Therefore, consider the monitor as a "dumb" unit that only displays information coming from your computer. Also, this unit does not have a HDMI input, but only VGA.
So, you are fated to have this monitor connected to your computer, always.
Now, you may find good software that will "tune" the TV signals from streaming at the Internet and show whatever is being broadcast. The same way you can access YouTube and watch videos these TV tuners will get the streaming signals the TV stations send via Internet (not all do that) and watch the channel in your PC/monitor
Since I do not have additional information about the computer you use I cannot give you other ideas
I hope I have helped you.

Remove the batteries from the remote. Other than that the TV's control board has gone wacky.

You need to replaced your Inverter Board, If you can do the job, get the Board Part number and order it from Westinghouse. If not call a Professional TV Technician. At least you have an idea what's the trouble with your set. Hope this Tip will help you.Thanks

Take a strong light and put it up against the screen. Do you see a faint image? if yes, then your backlight has failed. Could be a lamp, inverter or power supply issue. Not for DIY'ers.

turn the timer off.