What does maintenance required code CA refer to?

Hi, TA code refers to maintenance all counter has reached its specified limit. This usually means all the consumable parts have reached the end of their service life. If you have a maintenance contract with a Sharp dealer then they should replace all the units that require replacing & reset the maintenance counters for you, if you don't then, if the copy quality is still ok, you should be able to continue to use the machine as normal.
Hope this helps.
Dave.

Link to user manual.

http://www.sharp-cee.com/cps/rde/xbcr/documents/documents/om/34_ppc/MX2614N-2615N-3114N-3115N_OM_GB.pdf

The TA code refers to the maintenance cycle of the copier. Its the copiers way of saying ''come and see if im ok''. I would recommend resetting the maintenance counters for your drums, developer, fuser and transfer belts. This can be done in the engineers menus.

other than uninstalling CA, it has a minimum memory requirement of 512k however it runs like a dog on this am mount , it is recommended that you have at least 2gb of RAM to run CA antivirus.

Ok so the DK code means that the Black drum counter has reached its limit
To clear this you need to clear this easy you want
# , * , c , *
To enter service mode
Type in code 24 press start
Then you want sub code 07
Then you can select what you want to clear so the bk drum unit
Execute this yes then press the CA key the machine will restart and away you go
I also do advise that you service representative comes along at some point to check the machine it could need parts because if you stretch the life of parts your machine could become unreliable... But that is up to you.

Ok so the TA code means that the all maintenance counter has reached its limit
To clear this you need to clear this easy you want
# , * , c , *
To enter service mode
Type in code 24 press start
Then you want sub code 04
Then you can select what you want to clear so the maintenance count all
Execute this yes then press the CA key the machine will restart and away you go
I also do advise that you service representative comes along at some point to check the machine it could need parts because if you stretch the life of parts your machine could become unreliable... But that is up to you

reset it by simulation no 24 n then ul get t detail

The service acces code C-0-0-C,or C - interupt key -0-interupt key.Acces the list of commands maintenance preset counter setting and set to a new value,or maintenance counter clear.