-
Master
666 Answers
- Posted on Apr 22, 2010
Re: I need the code for sharp tv please
Configuring codes:
- Turn on the component that you want to set up. In the code listing
find the 4-digit code numbers for your component brand.
- Hold the component key down until the green indicator light
comes on. The green light should come on after approximately 3 seconds.
- Release the component key.
- If you are programming the DVD or CD device press the
"action" key. The red indicator light will come on.
- Within thirty seconds, enter in a 4-digit code number. The
component key lights will blink with an upward motion when a code has
been successfully entered. In this case proceed to step #5. If the code
has not been successfully entered, the componment lights will not blink.
In this case return to strep #1 and start over.
- Test code by pressing "Power" key. If the component turns
off, you've got the right code. Follow the same instructions to set up
your other components. If the component doesn't turn off, return to step
2 and use the next 4-digit code listed.
Note: If none of the codes turn your component off, try the Auto
Code Scan function.
Auto Code Scan:
The Auto Code Scan feature allows you to set up your components without
having to enter in code numbers. The Jensen will do the work for you!
(It may take a few minutes to find your code using this method.)
- Turn on the component that you want to set up.
- Hold the component key down until the light comes on. The
green light should come on after approximately 3 seconds.
- Release the component key.
- If you are programming the DVD or CD device press the
"action" key. The red indicator light will come on.
- Press "0" - "9" The green light will blink as codes are
sent.
- As soon as the remote turns your component off, press the
"action" key. (You have 1 second in which to press the "action" key to
save the code.) The component key lights will blink with an upward
motion when a code has been successfully entered. The component is now
programmed. To find that code, proceed to Code Readback.
- If none of the codes turn your component off, return to
step 2 and start over.
Code Readback:
- Hold the component key down until the green indicator light comes
on. The green light should come on after approximately 3 seconds.
- Release the component key.
- If you are programming the DVD or CD device press the
"action" key. The red indicator light will come on.
- Press the "enter" key.
- Count the number of times the green light blinks. There
will be four numbers, separated by a two second pause. The red light
will tum off after the remote is finished reading numbers back. Make
sure you write the code number below for future use!
Multi-Component Power On/Off:
The Jensen remote has the ability to turn On/Off multiple components at
once. When you perform the following steps, you can turn On/Off the TV,
VCR, Satellite, Cable Box and Audio Receiver.
- Press the "action" key.
- Press the "power" key.
Note: This feature does not work for DVD and CD.
Volume Priority Punch-Through:
When you press the volume keys on the remote they will control the
volume on your TV. If you have a home theater system and want the volume
keys to control your receiver only, you may set your volume priority to
the receiver.
- Hold the "RCVR" key down until the green indicator light comes on.
The green light should come on after about 3 seconds.
- Press "RCVR" key.
- Press "Vol+" key. To disable the volume priority you have
to set and return to the default.
To change back to TV priority:
- Hold the "RCVR" key down until the green indicator light comes
on. The green light should come on after about 3 seconds.
- Press "RCVR" key.
- Press "Vol-" key. The volume priority will now default to the
TV volume.
hope this helps
Robb
×