Display flashes 88:88 and won't start - Electrolux EIED55H Dryer

Car Won't Start Because of Anti-Theft System ... - RepairPal

repairpal.com > Problems > Oldsmobile > 88

Car Won't Start and Security Light is On on Oldsmobile 88 ... key turns over enginebut fails to start some times..security system keeps the fuel injectors from ...

Car Won't Start Because of Anti-Theft System ... - RepairPal

repairpal.com > Problems > Buick > LeSabre

Car Won't Start and Security Light is On on Buick LeSabre. Problems with the ... 1998 Buick LeSabreVisitor. Turn key on every thing come on but won't turn over.

Car Won't Start Because of Anti-Theft System ... - RepairPal

repairpal.com > Problems > Pontiac > Bonneville

Replaced trans, engine, PCM and bcm, now starter diabled- theft flashes on service ...1995 Bonneville car turns over but wont fire an security light is flashing car ...

GM Passlock Security Light Issues - RepairPal

This is taken directly from the Samsung website:French Door: Why Is The Display Blinking 88 88 And Not Responding?Cyber

Drastic power fluctuations such as power outages and surges can cause electronic device to behave abnormally. If the refrigerator display is showing 88 88 (all eights) and is still cooling properly, unplug the refrigerator for 60 seconds and then plug it back in. If the display returns to normal after approximately 2 minutes service is not required. However, if the display does not return to normal service is required.

Unplug the unit for 30 mins. then plug it back in.

No! this indicates a keypad control board issue.

Pump or injectors may be bad .

The "88 error code" is for a bad control board. Here is a link to the part you need.

Richard Roth

The FixYa Team

88-89 Flashing Reverse 9.
I noticed this occurs when the Ice Machine get jammed up.
Remove all ICE from Tray and Clean.

Press and Hold Energy Save+Alarm Button for 10 Sec.

reads 88 deg/ ok is frig that warm also .. if so replace the p c control as it has gone bad . in some models they call it a jazz board . / there is a update and it works much better .. mm

Try a new battery. That is usually what "88" means.

This error only shows in diagnostic mode, with power off choose any buttons except stop and power, press in intervals 5 seconds on and 5 seconds off until 88 appears and all light light up. If the user panel is faulted F 2 will flash in the display, press the same button you used to start diagnostics to jump to the next error code and once through 88 will flash and diagnostics will start. Sometimes once F2 flashes and the machine has not been repaired it will stick at that mode.