Tv doesnt respond to buttons or remote

Chances are you have a stuck button on the button cluster, what I'd do is remove the connector going to it and use the remote control, with a stuck button the remote won't function properly.

The buttons on most remotes are the soft rubber type. The conductive film under the rubber is very thin and gets damaged very easily when pressed really hard. If you can still change the volume using the buttons on the TV and one or more buttons on the remote works and not works at times then it a bad button on the remote. Unfortunately you can't just change a single button as it's mounted on a pad. The whole remote needs changing. Check with TV vendor or look for a replacement on Amazon.com. Try to get the exact model and avoid using a universal remote. Yes, they work for basic functions but won't have the specials lik PIP (picture in picture).
* Oh, if your using a cable box. You may be able to program the cable remote for use with your TV (at least to control power and volume) Check you cable channel for setting up the remote. (They usually have a dedicated instruction channel.)
Aloha, ukeboy57

open the remote case resolder dry joints

Some of these remotes are also made to run other components,so be sure to press the "tv" button and try the vol and channel again!

There is a similar problem here.

U have 2 situations:
1st U have a tv Key stucked or internal control board defective.
2nd U have a broken tv remote control.

Note: Check for stuck pressed keys on TV, if not send to repair shop, for checkup.

bought beko 32 wlu520hd when i change channel or volume the white indicator light on the tv flashes and starts going through all channels or volume just keeps going up .as if im holding down the buttons when im not , buttons on tv and remote do not respond. until i rub my finger over the senser on the tv, it stops but as soon as i press any button on the tv or remote it starts all over again .is this a fault in tv or is it static build up, does any one have the same problem , ive been on the beko web sight and cant find anything about this

Unplug the television from the wall outlet, and then replug it after 60 seconds.

Perhaps you can try what I do when my KV24FV300 runs through channels and will not stop.  Hard to watch and remote will not work.  Nothing works but on and off from set. 

Sony Says:  Take all batteries out of ALL remotes that you use in any way for that set, VCR, etc.  ALL batteries out.  Turn TV off at set.  Unplug TV.  Wait at least 15 minutes then replace all batteries in ALL remotes.  Plug TV back in and turn TV on from set.

Maybe, just maybe it will work.  If it does not work why not call Sony, they always say that cannot happen but they have a solution for it.

[email protected]

the channel down button is stuck on, you need to replace this switch internaly to the set.