The fan needs to be cleaned. Removed all the screws, but there are clips that hold the "accordian" extender screen and does not allow us to separate the front and back panel.
No mention in the Instruction leaflet how to dismantle fan to clean it. Anyone have any luck doing this?
Thanks
SOURCE: how to set the temperature
Look up this fan on amazon.com. In the comments/reviews a gentleman posted instructions for fixing the thermostat (it involves opening up the fan and repositioning the thermostat wire).
SOURCE: Fan blades are filthy!
put motor oil to the midst of your fan blade may there are lots of rust inside then wait 5 hours then try to pull again patiently...
SOURCE: i have bionaire cleaning product but no directions on how to use
the cleaning product that you have you need to use once cap full per gallon of water. so if it's 5 gallons you need to use 5 cap fulls. so forth and so forth. that is the easiest way to tell you. and then you let the unit run with the solutions and the water for the hole time until the water runs out. and your unit will be cleaned
SOURCE: I need the operating instruction for Bionaire BCM2200...thanks in advance
Go to manufacturer website for manual download.
SOURCE: how to set the temperature
THE RELEVANT PART OF THE AMAZON REVIEW IN QUESTION:
How to fix it:
WARNING: Before opening the back of the fan be sure to unplug it first! Don't electrocute yourself, please. Next, once all the screws have been removed open it from the side without the expander. You won't be able to take the back completely off but it opens wide enough to get your hand in there. Be careful. Don't blame me if you crack the casing or hurt yourself. Plus, opening the fan voids the warranty so proceed at your discretion. The thermostat wire on this model is a thin black wire about 3 inches long that is tucked under the circuit board on the right (if the top of the fan is closest to you when you've opened it). I stretched it out, taped it in place, and now it works like it should! When putting the fan back together the plastic part that covers the circuitry also houses the upper arm of the side extension so the arm should rest just inside the lip.
842 views
Usually answered in minutes!
×