Washer stopped during spin cycle

washing machine stopped mid cycle, won't drain : DIY - Reddit

https://www.reddit.com/.../washing_machine_stopped_mid_cycle_...

RedditSep 3, 2014 - helpwashing machine stopped mid cycle, won't drain (self.DIY). submitted 1 ... I get home. Any ideas on how I can just drain the water out of it?

Troubleshoot - washer stops mid cycle, won't drain or spin ...

? 1:58
https://www.youtube.com/watch?v=6Gc0ZgLD6a4
Jun 20, 2012 - Uploaded by searspartsdirect
Troubleshoot - washer stops mid cycle, won't drain or spin .... I agree, this was not helpful, and did not address the no spin issue. like thanks. ... how to fix a Kenmore / whirlpool washing machine that wont drain agitate or spin ...

Washing machine stops mid cycle - White Goods Help

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Sep 9, 2013 - Possible causes when washing machine stops mid cycle by a ... If thewashing machine can't drain the water out then it will stick on the rinses, ...

Why does my washer stop half way through cycle - Ken

does it stop mid cycle? do you hear a hum, like its trying to drain but can't? Something may be stuck in the pump. It may also be the lidswitch if it is just stopping and not doing anything when it's supposed to drain.

does water come in the washer.

Replace the timer, you can find the product name model and serial number on two place. Either the back panel or on the lid underneath. Please rate if this helped thank you

This is probably normal. There is a natural pause between agitating and draining, and again between draining and spinning. Hope this helps!

defective timer...a model # should be under the lid...or open dryer door and on front dryer panel right hand corner..onthejob

i also had the same problem, and it ended up being the coupler. It was not hard to replace, it cost me about 19.00. I didn't follow full recomende instructions. I tipped the washer backwards. Removed the drain pump and the motor itself. Then I removed the old coupling and placed the new one. The washer is working like new...

make sure you have cold water unit rinse in cold water only,,even if it says warm...check the inlet vavle it should be humming in rines the cold sideof valve,,if not humming replace,,if working ok replace lid switch

if it stops at #6 u need to change timer and motor

You have a sock caught in the pump, need to pull off outer case and remove pump and clear it out.