The code E68 indicates that a button is stuck. Check the buttons by pressing them one by one to find the stuck button.
I have tried pressing all the buttons as you suggested. The problem still persists, however it is only doing this on the automatic drying cycles, and not on the timed only cycles. Any other suggestions?
Enter the service diagnostic
mode and perform the key test to determine which key is
stuck.
Once the key is determined, try to unstuck it; replace the
electronic control board if the
error code
continues to appear after the button is unstuck.
Press and hold simultaneously the Select and Cancel buttons for six
seconds to reset the control then immediately after the buzzer sounds,
turn the cycle selector knob 5 clicks counterclockwise to
position the
cycle indicator light second from the bottom.
Press and hold the Options and Cancel button simultaneously for two
seconds to enter the service diagnostic mode. The buzzer
will sound
three times and all of the LEDs will flash indicating the
service
diagnostic mode has been entered successfully.
Rotate the cycle selector knob 4 clicks to the Heavy Duty
cycle; the
motor runs with the heater off. The buttons can now be tested. Press
each button and all corresponding LEDs should flash;
otherwise the
button is stuck or a faulty. Unstuck the key and perform the key test
again; replace the control board if the problem is not
resolved.
Access to the control board requires the removal of the top
panel and
the console. Disconnect power to the dryer prior to servicing to avoid
the risk of electric shock.
Remove the two screws attaching the top panel to the rear of the dryer
then slide the panel rearward and lift it off the dryer.
Remove the four screws, two on each side, securing the console
to the front panel then flip the console forward. Disconnect the wires
from the control board and lift the console
off.
Remove the screws mounting the control board to the
console and
lift the control off. Remove the control board's rear cover by
releasing the two locking tabs the flip the cover off the control
board. Try to unstuck the faulty key and reassemble the dryer in
reverse of the disassembly steps
need to replace the electronic control board where to get the part?'
×
4,321 views
Usually answered in minutes!
×