What does E68 code mean? - Microsoft Xbox 360 Console

E68 error code is a stuck button error code. You can try to wiggle each button on the control panel to make sure they are all functioning freely. If so, then unplug the dryer and leave it unplugged a couple minutes then plug the dryer back in to clear the electronic panel's error code. If the panel still shoes E68, then you'll need to replace the panel. Part#134557201

Hope this helps!!

E68 for this model number says in manual that this is for a "button stuck" or held down for more than 30 seconds

ck all your buttons for one that just doesn't "feel right" when its pressed , this one will be your problem

Hello Erik;

My name is Peter. I am a retired field service appliance technician.

The code E68 appears when one of the buttons on the keypad is stuck in the down position. This is a common error with several different Frigidaire dryer models and tends to occur when the dryer is five or more years old. You may be able to un-stick the offending key manually. If not, you will need to replace the entire keypad.

Good Afternoon David,

I understand that your Frigidaire Affinity dryer, model# LEQ6000ES2, is showing you an error code of E68 and will not start. I also see that you have changed the thermal limiter. Looking at what the E68 error code means, a key or button stuck, there could be something else causing the code to come up. I suggest contacting your local authorized technician for further assistance. They will be able to diagnose your appliance, determine what is causing the E68, and repair your dryer. Hope this is helpful.

-Best Regards-
WP

Good Morning Mua_m7,

I see that you are having trouble with your Frigidaire washer giving you an E68 error code. The E68 could be one or both of two possibilities.

First, it could be the heating element. If the heating element goes out, this means that you would be unable to get the water temperatures to hotter temperatures.

Second, it could be something going on with the main control board inside your washer.

With you receiving the E68 error code, I suggest that you give your washer a hard reset, by either unplugging it or shutting the power off at your home's circuit breaker for 2-3 minutes. When you restore the power, if you are still receiving the E68 error code, I suggest contacting your local authorized technician for further assistance. Hope this is helpful.

-Best Regards-
WP

The 9-volt alkaline
batteries are low

Hi yoyosam66...
Your e68 error code means:
Please take time to rate me
-----------------------------------------------------------------------------------------------------------------------------------------------
E68 - Push button does not function
Cause:
Push button held too long or wedged in the control panel. Solution:
Press buttons lightly and release.
Disengage button.

The error code E68 means a key or button is stuck. Check the buttons by pressing them one at a time to find the stuck one or enter the service diagnostic mode then the key function test. Click on the link below for the detailed instructions.

Troubleshooting Error Code E68 on Frigidaire Affinity and Gallery Dryers

hello e36 means control board problem E68 means current leakage to ground on heater or fuse opened

shaun

E68 means one of the buttons is stuck. Try pressing the buttons lightly, or disengaging them with a small tip.