My GE Security DVMRe-16CT-1000 16-CHANNEL I power

If memory serves me correct, most of the GE/Truvision etc. DVRs have to be sent back in for the password to be defaulted. I may be incorrect on this, will double check.

The DVMRe uses a 12VDC, 4.0A supply. with center +
It's a standard barrel-type connector.
Note that if the supply isn't capable of 4 Amps or better, the unit will turn on, then go back off immediately, then try again forever

3123
3477
6321
1111

lookup this site for details www.portforward.com about forwarding ports.

john s

From the user manual page 71:
5.2 Quick Archive to CD
Archive to CD on the Disk Analysis Screen by selecting the time and date and pressing the record
button. The QuickWave Setup must be set to ON from the Archive Setup → Quick Wave Setup menu
(see section 3.15). The Archive Incident menu should appear.
1. Use the Jog to modify the time parameters and use the
Shuttle to move between the Start and Stop fields.
2. Press the Record button on the front panel when satisfied.
3. The CD Writer will open the CD tray when completed.
The video may now be viewed on any PC equipped with a CD-ROM.

You can download the complete user manual here:
http://www.gesecurity.com/portal/site/GESecurity/menuitem.f76d98ccce4cabed5efa421766030730?selectedID=1965&seriesyn=true

I would switch monitors and see if the problem still exists. Sounds like the monitor not the Dvmre.

Go to this site and download WaveReader software.
http://www.gesecurity.com/portal/site/GESecurity/menuitem.11620ebca5cc0a06574efe10140041ca/?vgnextoid=4f9fe4997e789110VgnVCM100000592d7003RCRD

The factory default code to reset the system is 8111, however this will reset all program functions back to the factory settings, with the exception of the time and date. The default Operator code to use the system is enter, enter, enter, enter. This should allow you to operate the system.

Check in the settings and make sure it is selected to be on.

I have strongly recommended that change your power supply with the same specification voltage and amp. I have installed so many GE DVR's most of DVR's restart when the power supply is not working properly or HDD have bad sectors. I also recommend use the scan disk on you HDD for proper checking of your HDD.

FROM
AI