Help me clear the system error C2202 on my kyocera KM-C2630D. multifunction copier
Check the charging unit and transfer unit, or because they are spark.
Solution ID TAUS0703124EN* Solution Usage 1
Description
Why is the image rotated 180 degrees when copies that are not stapled exit the machine?
Solution
CAUSE: Firmware update required.
SOLUTION: Switch 25-6has been made available to address this issuewith the release of version 30 firmware. Please update the machine firmware to
version 30 or above and set Switch 25-6 to1 (ON).Please follow these steps to set Switch 25-6:
1. Enter Service Mode.
2. Select System 2.
3. Select DipSW Setting.
4. Enter 25 under SW No.
5. Enter 6 under BIT No.
6. Select 1 (ON).
7. Select SET.
8. Select OK.
9. Exit Service Mode.
Note : The latest version firmware or system software is available via the Konica Minolta Download Selector. Access the Selector from SSD Web Support
(CS Expert Support) by clicking on 'Download MSDS, Drivers, Firmware
C-2202 on a KM Bizhub 500 indicates a drum rotation problem. The best thing to do is open the machine up and look for a paper jam or something. Then try turning it off/on at the main power switch for 10 seconds (switch inside the front door)
Other than that, if the code comes back you'll need to call someone out.
Regards
m-press.biz
2101, 2102, 2103, 2201, 2202, 2203, 3101:
The network cable is disconnected or the hub that it is connected to is not operating properly. Check the cable and the hub. Otherwise, the server name or the host name of the SMTP server is
not set correctly. Use COMMAND CENTER and register the SMTP server name and the host name
correctly.
2204: The E-mail size exceeds the acceptable send data capacity. Decrease the size or resolution of the scanned data to be transmitted and resend the E-mail. 5101, 5102, 5103, 5104, 7102, 720f:
Turn the main power switch off and back on. If this error occurs several times, make a note of the displayed error code and contact your service representative.(Refer to the corrective action for the error message " An error has occurred.")
9181: The scanned original exceeds the acceptable number of pages of 999. Send the ecess pages separately.
Hope this is helpful,
Shawn
1,865 views
Usually answered in minutes!
×