Pairing instructions for motorola H500 headset

Turn your h500 off. Then long press the multifunction button untilnit lights up steady blue. Then search on your phone to locate and pair with the headset.

Mark
Motorola Support

Pairing mode is what is shown in the picture. The headset has a steady blue light and is ready to be paired with another device.

Mark
Motorola Support

Turn the LG Shine off, wait 10 seconds and try again. Power cycling the phone really does help sometimes. Let us know if this doesn't work.

I had no problems pairing H500 with my BBerry Curve, but I did have download installation instructions to ensure I had the H500 set up correctly- must have continuous blue light before starting to pair. I enable the BBerry Bluetooth and selected find and there it was. Put in passcode 0000 and it connected just fine.

TRhe pair code for my motorola headset is 0000 (that's zero zero zero zero)

the pass key is "0000"

Try the steps listed in the solution found here
http://www.blackberryforums.com/general-blackberry-discussion/18109-bb-7520-motorola-h500-pairing.html
Hope that helps

See the user manual page 59 for instructions on how to pair the device from the 8800. You only have to do this once.
The passcode is 0000 for the H500 which is unalterable.

It might already have been figured out but if you hold the answer button on the headset down until the light stays on steady, it is in pairing mode. You can then go to bluetooth setup on the Curve and it will find the headset.

If you turned it on and it was steady blue most likely you held the call button too long. The steady blue means it's ready to pair with a phone. Try repairing again and if you still don't hear anything, play with the volume buttons to the top and buttom of the headset the volume may be down. If that doesn't help I don't know what will.