When the screen crack can iput the screen offf and tint the glass in the back

Hi,

please check your display settings to adjust them and help overcome this issue. I would test setting like tint/hue in order to get rid of the orange bars. Thank you.

Put the tint back.

https://www.google.com/search?q=telefunken+projector+model%3ATP-2000+white+screen

..

If you have window tinting on the back glass, it will cause poor reception. If there is no tint, check the wiring near the top of the back glass for looseness or corrosion.

Sharp razor blade. You can buy them from an auto shop pack of 5 - 100 i think. Takes ages but you just scrap the tint off. I have asked a tint shop 1/2 way through ding this & they advised me that was the corect method.

If you have no joy anywhere else, you could try the Aramani service center. Below is an extract from their web site.

"If you have questions about Warranty or Repair please contact us at:
800-277-4013 Available M-F between 8:00am – 6:00pm CST
[email protected]"

It is broken,The outside is a Polorised film.Like window tint,It is repairable,New LCD screen.But may be cheeper to buy a new TV. GET A EXT.WARENTY!!! will not cover accidents but the new tv's do break alot,and are expensive to repair.
Buy a name brand, NOT RCA "junk" Just a name
no longer a company. Samsung,Panasonic,Sony. If you want to support the USA buy another Sharp. Still a great TV. And made in America. NOTE they make after market screen protectors. GOT KIDS? GET ONE. :) Or even a piece of plexie glass if cash is tight. Hope this helps.

You'll find it's bonded "glued" to the glass, if you try to pull it off it will probably crack the screen as it is laminated and each layer is only 2mm thick or so.
Your best solution would be cutting the tint to size and cutting around the mount putting the split above the mirror mount. As you would cut wall paper around a light switch in a cross then trim to size with a sharp blade.

if you have the No-Nav system and/or the antenna is in the rear glass, then yes it's will effect signal strength. Some ppl with dark tinted glass have complained.

unfortunately the process cant be reversed. the glass filter have (which is in plastic material) has to be replaced by a new one. it is recommended to clean the screen using micro-cloth only.

It may seem easier to tint them out of the suv, but it is very easy to damage them putting them back in. pre-cut the tint material on the outside of the glass. Make sure you have the tint on the correct side when pre-cuting. leave a 1/32 gap around the tint edge when pre-cuting. That will keep the tint from binding up around the edges. Also the soapy water has a way to escape. Make sure the glass is as clean as possible.