Standby light flashing

The flashing standby light on your Luxor TV can indicate several things, including:

1. Power supply issues: If the TV is not receiving proper power, the standby light will flash.
2. Malfunctioning hardware: A malfunctioning component in the TV such as the power supply, main board, or backlight system can cause the standby light to flash.
3. Overheating: If the TV is overheating, it will go into protection mode and the standby light will flash.
4. Software issues: A software glitch can also cause the TV to display a flashing standby light.

If the flashing standby light persists, it's best to unplug the TV, wait a few minutes, and then plug it back in. If the problem persists, you may need to contact the manufacturer or a professional repair service for further assistance.

It may be the eprom (memory ic) is corrupted and needs replacing it is a job for an engineer

Hi.

The TV starts in forced standby. The state is also called "Protect Mode". Protect mode kicks in whenever an internal fault is detected. The error is detected by controller circuit and the PSU is forced in standby mode, shutting down all voltage lines apart 5VDC to keep standby on.

First try disconnecting the power cord for ten minutes, reconnect after ten minutes and restart the TV with no device connected.

If that does not help it means that there is an internal fault and that the TV must be tested and repaired replacing the defective part.

The defective part is usually the PSU. Among components that fail quite commonly there are the capacitors on the power board. If the capacitors look swollen or if there is trace of damage on PSU board, then the affected parts must be de-soldered and replaced. If there is no evidence of damage at a glance the parts must be tested using a multimeter and following schematics from service manual.

If you need to call a technician use the phone number listed on the owners manual or on the manufacturer support web page.

Regards.

Ginko

Unplug unit for a couple of hours. That may reset any problems it may have.

When it is off and plugged into the wall outlet the standby light will be on. The stadby light will go off when power button is pressed. If not there is poblem that needs service.

that is becaus eit should only come on when on stadby

unplug the printer and press the ON BUTTON then insert the plug.again press the ON button 1 more time.it will start moving and come to the position.

I had the exact same problem. Solution is to update phone via sony ericsson support site. Ensure you have backed up your phone first as alll numbers and ms will be lost. I have had no problems since the update 10 days ago

sticks on standby

Usually resetting a device like that is done via it's On Screen Display (OSD). Maybe you need to contact Sony Tech support.

You can do this by clicking the below link:
[Sony Tech. Support]

Let me know if they have a solution to your problem.

Greetings,

DarkNeogen