Reset fotoconductor lexmark e352dn - Lexmark Lemark E352DN Laser Printer

Ideally the printer should be connected directly to the wall outlet not to a UPS or surge protector.
If you experience the same issue please contact Lexmark Technical Support for further assistance

Hola Juan,

Por favor, haga clic en el enlace http://bit.ly/qjm484 para obtener instrucciones sobre c?mo hacer el procedimiento.

Para obtener asistencia adicional, p?ngase en contacto con asistencia t?cnica de Lexmark

please remove the ink and replace then restart. please vote on this answer.. thanks.

Here's an article on How to Change the Photoconductor Unit/Kit on a Lexmark E250d(n), E350d, E352dn, or E450dn Printer. Just click on this link: http://bit.ly/aykTXL. This should give you an idea on how to install the photoconductor unit in the Lexmark E352dn printer.

NOTE: If you are replacing your old photoconductor unit with a new one, after installing it you will need to reset the photoconductor counter as well.

3S0500 is the Product Code for the Lexmark E352dn.

Lexmark does not make the Service Manuals for its products available to the general public. Sales of this manual are restricted to authorised service technicians.

What problem are you trying to resolve, maybe I can help you?

Don

you see your printer feed sensor or delivery sensor is open chack it

Hi,


The above error code refers to :-

The Transfer drum has reached the end of it's life and must be replaced. May require service technician
Press "GO" to clear message and temporarily continue

Hope i helped you.

Thanks for using "Fixya".

please clean printer fuser or clean thermostator

Reset Procedure(s) after putting in new Photoconductor kit
Resetting the Lexmark E340/342 (display type) machines
1) Turn the printer off
2) While still off, press and hold the SELECT and RETURN buttons.
3) Keep both buttons pressed, and turn the printer on. Continue to hold both until either “Performing self test” or “Config menu”
appears on the display.
4) Release the two buttons
5) RESET PC CNT should now show on the display. If it does not, press the left or right menu buttons until it does.
6) Press the SELECT button once. “Resetting PC Cnt Value” should show on the display.
7) When the display shows CONFIG MENU again, turn the printer off.
8) Turn the printer back on. (Do not hold any buttons down this time). The printer is reset.
You can confirm the counter was reset by printing a “menu settings page”.