Fisher & Paykel Washing Machine IWL12

Error code 130
Watch this
Fisher and Paykel 130 10000010 Error Code Fix

the R.P.S or rotory postition sensor is faulty or the connections are corroded

What lights are lit on the display?

107. (01101011) Motor Control Module Reset Error
The Display Module has detected that the Motor Control Module has reset when it should
not have. This can be due to a Motor Control Module supply disturbance or microprocessor
failure.
Primary Source: Motor Control Module.
Action: Replace Motor Control Module.

Rotor position sensor fault, a little green circiut board located on the motor itself.

Hi, this is an update on what I found out about the E51 error code from Fisher & Paykel. This code is an error with the internal memory as one of the previous poster's said. Fisher & Paykel Rep said though it wont hurt the function of the machine it should still be replaced because it may effect the compliance information.

intuitive ECO Model IW811 display error code 49...any one can help me

Hi just read your posting.Error Code 130 means your fault is called Single Rotor Position Sensor Error.This component is attached to your motor which is underneath your machine.What concerns me is your machine is leaking.Did the Error Code appear the same time your machine started leaking?The reason I am asking this is because the water could have damaged the rotor sensor.Is the water leaking underneath the machine?Please reply with additional information and I can help you rectify this fault.

http://www.docstoc.com/docs/25379715/Fisher-_-Paykel-Washer-Diagnostic-Fault-Codes/
A;; fault codes above.

needs a new Rps sensor , 130 is a fualty Rotor postion Sensor