Epson cx11n major printing problems

i am correctly facing this type problem i found searching from goole and visit this site all problem solve just few minute thanks for this site. https://www.epsonprintersupport247.com/fix-epson-printer-offline/

Hi

The printhead of your color cartridge is clogged
or is near to end
you need to replace the color cartridge or refill it (cheaper method)
check here how

this could be due to the sensor at behind of the printer.. you should be able to see it once you open cover E.. it's very delicate plastic and normally when you clear the paper , you might accidently damage it.. you will need to open the read feed assy to fix it.. 4 screws and you should be able to remove it.. but first remove the E cover but slightly forcing the lower left hidge.. use a test pen...

Hi

Try taking out all toners and reinstall them. Turn on unit, without Photoconductor, wait till you get error install photoconductor. Insert photoconductor and try printing again.

Hope this helps

I don't have an answer for you but I have the exact same problem.

I have an Epson Stylus Color 777 and I put in new cartridges (black and color) that I bought yesterday (03/05/10).

I pulled the tape off the cartridges and inserted them in their carriages. Everything works like usual except that no ink at all prints on the page. Comes out completely blank.

from what you are saying, if color is fine and black is not, its most likely the black drum that is the problem. the toner is part of it. try taking the black toner out and shaking it, and putting it back in, if it still does not help, most likely it is the toner/drum.

thanks adi

epson uses pigmented ink and compatibles use dyes and thus if the paper is not of good quality then you can have this problem.

do the following

change the paper and try.

As there will be ink in the head and the ink feed tubes , print some 10 -15 copies of all color prints so that the original ink starts to get into the head and then the paper.

this should solve your problem

Also use your printer every 2 -3 days if you dont have any prints then give a noozle check and then switch off the printer. This will avoid the printer from doing a head clean very time you switch on the printer and also the ink will give you more output as there is less amount of head cleaning

bye

I have ordered a new photocunductor unit as i am assuming that the other one was faulty.

i think you have a corrupted driver- you have to uninstall driver first

1. Double click on the MAC HARD DRIVE.
2. Double click on the LIBRARY folder.
3. Double click on the PRINTERS folder.
4. Drag the EPSON folder to the trash can.

Go to print and fax and delete the printer name as well

Restart the Mac. (You do not need to empty the trash.)
If you have not done so already, please follow the steps below to download the latest driver for your printer in OSX:

1. Go to the following website: http://support.epson.com
2. Under the PRINTERS heading select INK JETS and then the Stylus Photo R2400.
3. Under the DRIVERS & DOWNLOADS section select MACINTOSH.
4. Select and download the following file for your operating system

which mac are you using? tiger ot leopard? intel core or powerpc?

paper too thin 80gsm is too thin..try100. hope it solves your problem...did mine cheers derek