Is 5d or sd a code - Whirlpool Cabrio WTW6600SBT Top Load Washer

SOURCE: error code Sd (or 5d)

It means Suds Lock(Overdose of Detergent Detected During The Wash Cycle).If suds are detected continuously by the pressure switch during the drain or spin phases,the washer will fill 4 litres of water and during 5 minutes the unit will rest without tumbling,the water will be drained and it will try to spin or drain again.

If too much detergent was used:
– Run the unit through a Rinse/Spin cycle.
– Run a Normal cycle without adding any detergent.
This should clear the unit of the excess detergent.
1. Check the drain hose and make sure it is not plugged or kinked.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the drain pump,pressure switch and Central Control Unit(CCU).
4. Check/clean drain pump filter of foreign objects.
5. Plug in washer or reconnect power.
6. Check drain pump.
7. Check the pressure switch.
8. Verify CCU operation by running a Diagnostic Test.

SOURCE: Problem draining. Getting 5d code.

Hi


Thanks for using FixYa. Error 5d means too much detergent was used. Try the following procedure---

– Run the unit through a RINSE/SPIN cycle.
– Run a NORMAL cycle without adding any detergent.

This should clear the unit of the excess detergent. If still the problem persists, then please check the following things--



1. Check the drain hose and make sure it is not plugged or kinked.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the drain pump, pressure switch, and Central Control Unit (CCU).
4. Check/clean drain pump filter of foreign objects.
5. Plug in washer or reconnect power.
6. Check drain pump.
7. Check the pressure switch.
8. Verify CCU operation by running a Diagnostic Test or any cycle.



Please do rate the solution if the issue is resolved or else revert for further assistance.



Thanks
Rylee

SOURCE: troubleshooting code 5d or "Sd"

SD would be too much suds or the pump is clogged and can't remove the water fast enough.