I have a Nordtrack viewpoint 3000, the tv will come on and when I touch the start botton it just beeps.

Check if the machine is going through some kind of calibration, evidenced by humming of a motor. This check may take a couple minutes. If there is still not activity after your patient waiting, something may have to be repaired by an authorized technician or mechanic.

try first disconnecting tv from power for 20 minutes and see if problem disappears

NordicTrack Viewpoint 3000 30704 0 User Manual Page 30

open that and scroll down to....walking belt is off center.

Dear Sir:see the next video
sincerely. God bless you

Dear Sir:
Please see the attached diagram for adjusting the reed switch, clean very well, and tigh the connector wires.

sincerely. God bless you

Hi names Rui, i question for you does your PC give a beeping sound when you turn it on? if does can you tell me how many beeps it gives?

if it give a designated number of beeps this might be the problem i will give you a chart so you can differentiate the warning beeps you hear.

warning beeps:

1 Short Beep DRAM refresh failure
2 Short Beep Parity circuit failure
3 Short Beep Base 64k RAM failure
4 Short Beep System time failure
5 Short Beep Process failure
6 Short Beep keyboard control gate A20 failure
7 Short Beep Virtual mode exeption failure
8 Short Beep Display memory read/write test failure
9 Short Beep ROM BIOS checksum failure
10 Short Beep CMOS shutdown read/write error
11 Short Beep Cache memory error
1 long, 3 short Beep Conventional/Extended memory failure
1 long, 8 short beep Display/Retrace test failed

hope this will determine the problem if none of this warning beep is heard try reseting the power botton in you PC cause sometimes the power botton will loosen cause of continuous use of the botton.

hope this will help you.

take it apart (will need a sucrity screw driver) and clean the hard drive.

Check out my common PS3 problem and repair guide for tips and suggestions for your problem.

http://rescuetechla.blogspot.com/

Please feel free to email me any other questions and please don't forget to rate!

:)

Thanks!

RescueTechLA

Replace front panel board the one with off/on vol- vol+ channel- ch+.

if the ready light is off, and the error light is flashing, it indicates an interface error. please check all your cables.