How can I resolve kyocera fs 1016mfp error 6000? thanks

Broken heater lamp error
The temperature won't rise by 1°C/33.8
°F during warming up and the heater is
turned on for 5 seconds.
The temperature won't rise by 1°C/33.8
°F during printing and the heater is
turned on for 5 seconds with the duty
cycle more than 60%.

Causes:
- Defective fuser thermistor.
- Broken thermal cutout or heater lamp.
- Defective engine/high voltage PWB.


Follow the flow chart:

Turn power switch off, and
remove power cord.

Detach YC7 connector on
the engine/high voltage
PWB.

Measure resistance
between pins 1 and 2 of
the detached connector.

Open
(infinite)?

Yes ---> Replace the fuser thermistor.
NO ----> Detach YC1 connector on the power source PWB.

Measure resistance
between pins 1 and 2 of
the detached connector.

Open
(infinite)?

Yes ---> Replace the thermal cutout or heater lamp.
NO ----> Replace the engine/high voltage PWB.